Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Compressor Motor

Posts

Compressor Motor

#1

Compressor Motor

George@Colonel's Workshop-Havertown PA

>Good Afternoon Friends,

I had a Craftsman 2 1/2 hp/25 ga tank compressor which went south after 10 years. Naturally, Sears couldn't support parts for a pump replacement. I salvaged the induction motor, which has two capacitors. It has been sitting on my bench for a couple years. There is no external plate giving amperage/voltage but it ran on 110 household current. I am wondering what it is good for and if can run continuously, say if it were to power a light lathe or even a polishing head/buffing wheel. The arbor is fairly short, about 5/8th inch. It was a good little motor despite the Craftsman lineage.

George

Re: Compressor Motor

#2

Re: Compressor Motor

Denis Ch�nard, Orl�ans, Ont.

>'Afternoon Colonel,

I think you should have no problem at all. Given the way that compressor manufacturers inflated their HP ratings, expect about half of the stated power, around 1 1/4 HP. Plenty of power for what you have in mind.

I assume the motor is open drip proof, as most compressors in that size range are, so just be careful not to direct anything (chips, dust, buffing compound, etc.) towards the motor while in use.

FWIW, my bandsaw has a 3 HP "compressor duty" motor on it, and has no problems whatsoever (but lots of power).

DC

Re: Compressor Motor

#3

Re: Compressor Motor

Pete in Holland, MI

>Compressor duty motors normally have larger than normal capacitors to get compressors started, other than that, you can use it for what ever you need.