Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Classic Hatteras boat Interiors

Posts

Classic Hatteras boat Interiors

#1

Classic Hatteras boat Interiors

ron childress

>Really enjoying discovering your web site!

I am in the market for one of these old boats and of course the interiors are all Aframosia. If you wanted to put all the time necessary, and did not care about the cost, what would be the absolute BEST way to refinish these old boats inside?

I'm getting very confused about varnish, tongue oil, clear coats, etc....

Thanks in advance for any considerations...please be very specific, i'm not very "smart"...about wood finishing, know nothing at all, actually.

Re: Classic Hatteras boat Interiors

#2

Re: Classic Hatteras boat Interiors

Garrett in Victoria

>Hi Ron

I own a new-ish 40' boat, and know first-hand what's involved in maintenance, etc., etc., so I admire your willingness to take on a project like this. I assume you know about boats, and more particularly, about what to look for when buying older ones.

As to your specific question, much depends on what Hatteras used as the original finish, and since these were factory built, my guess would be sprayed lacquer, but I don't know for sure. Another factor, of course, is the condition of both the original finish and the underlying wood. If good, a careful cleaning with a solution TSP (tri-sodium phosphate available at any hardware store - to remove mildew, mold, grease and wax followed by a very/very light sanding with 600 grit paper would be enough prep to lay on a coat of wax or oil. When buffed up it should look quite good.

However, if, as is likely on a boat that age, there's dry rot or water staining from window or hatch leaks, or a lot of scratches and dings that go beyond 'patina of use', the order of magnitude of the work required rises exponentially. Unless someone else can tell you with assurance what the original finish is, you'll have to experiment in an area that is not too obvious, and apply small patches of whatever it is you want to use to see whether it will adhere and provide the outcome you are looking for.

Two useful websites to ask these questions on are:

http://lists.samurai.com/mailman/listinfo/trawlers-and-trawlering

and

http://www.passagemaker.com/

Cheers, Garrett

Re: Classic Hatteras boat Interiors

#3

I have been down this road on boat repair many....

Art Silva

>times and trust me, the exponential part of the job goes up exponentially. Good luck, Art