Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Santa needs help...and so do I...

Posts

Santa needs help...and so do I...

#1

Santa needs help...and so do I...

Rob Hix - King George, VA

>Hey all,

Help me make a decision here. Santa is asking for my Christmas list, and I am having trouble coming up with stuff this year. My shop is full, and I am having trouble with organization or I would go all out for some nice planes. But that is not going to happen this year.

After Christmas I am going to build a set of bunk beds and some stools and chairs. Needless to say I will be doing lots of mortising. I am considering either a router or a bench-top hollow chisel mortiser. If I decide on the router it will be either the Triton 2-1/4HP or 3-1/4HP. If I decide on the mortiser, my options are wide open.

So, if it were you and you were going to be building charis and stools, would you use but the hollow chisel mortiser or the router? If the router, would you get the 2-1/4 or 3-1/4HP?

Thanks in advance from both Santa and myself,

Rob Hix

Re: Santa needs help...and so do I...

#2

Re: Santa needs help...and so do I...

George@Colonel's Workshop-Havertown PA

>Good Afternoon Rob,

I have the capability to make mortises with either a mortiser or with one of my routers. I much prefer the hollow chisel morticer married to a cross slide vice. I use a Shop Fox mortising machine and Harbor Freight cross slide vice. Its a winning combination which takes almost no time to set up, and lets the work be advanced over the length of the mortise. Everything is in plain view, unobstructed by dust covered sub-bases or the router structure itself. So you can hit the layout lines dead on, perfectly.

I do hand it to those who use their routers. I admire their skill and eyesight. And their results are also very good. There is more than one way to skin a cat. Why not ask Santa to bring both? :<)

George

Re: Santa needs help...and so do I...

#3

Bart Goldberg

Re: Santa needs help...and so do I...

Bart Goldberg

>I 2nd the mortiser with cross wise vise option. I have the Jet benchtop and a Rockler Bench Mortiser table setup that I really like. (http://www.rockler.com/product.cfm?page=10173&filter=mortise). Make sure to get some mortiser chisel sharpening slips while your at it.

My 2 cents

Bart

Re: Santa needs help...and so do I...

#4

Re: Santa needs help...and so do I...

mdclor

>If Santa is agreeable and you have been very, very good, I would suggest the Powermatic floor morticer. I had the opportunity to work with one and it was waaaaaay better than my bench top Jet morticer.

Good luck,

Merle

Re: Santa needs help...and so do I...

#5

Re: Santa needs help...and so do I...

Rob Hix - King George, VA

>Merle,

I agree with that. I have had a chance to play with one of those also, but I cannot justify one of those. If I were going to be using it every day I may be able to squeeze a little justification out of it. Money is available for the benchtop. Neither money nor space is available for the floor model. I can dream though.

Rob