Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Question to cradle makers????

Posts

Question to cradle makers????

#1

Question to cradle makers????

Barry Irby

>I am making a cradle for dolls that has a stand and the cradle swings between two uprights. There will be a stretcher between the uprights. The question is, How do you join the stretcher to the uprights? That seems to be the critical joint. I thought about using a tenon through the uprights with a loose wedge at each end, but I am afraid that will be a shin buster. That would allow for disassembly, but I am not sure that is desirable. Any suggestions?

Re: Question to cradle makers????

#2

Re: Question to cradle makers????

Doug Turner

>I made a cradle for our son about 25 years ago and used wedged tenons. It was very sturdy, and the knock down frame was great for moving. The cross piece was about a foot off the floor and just below the cradle. AS far as I know it is still going strong.

Re: Question to cradle makers????

#3

Re: Question to cradle makers????

Kneale Brownson awaiting snow in N. MI

>What I did on the one I made a couple years ago was attach a plate to each end of the stretcher with glue and a couple screws from the backside of the plate. Then I screwed the plates to the uprights. That way, the plates could be unscrewed for disassembly/storage. You can barely see the plates on each end of the stretcher here.


Re: Question to cradle makers????

#4

Re: Question to cradle makers????

John E in SC

>You're right - that is a critical joint that takes a lot of stress. (Yes, I learned that from experience after having to rebuild one of my early attempts - fortunately, an accident during finishing caused the joint to fail BEFORE it was holding a baby!) I would definitely do mortice and tenon. Wedges certainly help with strength, but they wouldn't necessarily have to extend past the upright. You can angle the top and bottom of the mortice slightly, and cut off everything flush after driving the wedges in the tenon. Of course, this prevents disassembly for storage, but the cradle itself is what takes up the most room - the stand doesn't really add a whole bunch. Just remember, your cradle will be holding precious cargo - build it with that in mind.

Good luck. Would love to see pics when you're done.

John

Re: Question to cradle makers????

#5

Ellis Walentine

Re: Question to cradle makers????

Ellis Walentine

>You're talking about some kind of tusk tenon joint, and it is indeed a potential shin buster, though your design will have a lot to do with this. But, if it isn't important that your frame knocks down for storage, I'd go for something strong and permanent, namely a through-wedged tenon joint. Ian Kirby and others have detailed the construction of this joint on numerous occasions. If you need more detail, either I or one of our other experts can sketch it out for you. This joint will last many lifetimes in normal (even severe) conditions and will not loosen as many tusk tenon joints will depending on your selection of species for the joining members and the wedges.

Ellis Walentine, Host

Re: Question to cradle makers????

#6

Thanks guys....

Barry Irby

>This is a smaller cradle for dolls. The really precious cargo will be on the outside putting the dolls in. Its her little shins I am concerned about. I like the knock down idea. It seems it would make finishing it and transporting it easier, but after that I think the tusks would do more harm than good. So I either need a sturdy joint that is not an ankle biter or I will assemble it permanently.

I am also thinking I will put the stretcher close enough to the bottom of the cradle that it will prevent the cradle from flipping upside down. I think there is the possibility she would fall and turn it over, sort of a loop the loop.