Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Planing cut-outs

Posts

Planing cut-outs

#1

JL

Planing cut-outs

JL

>I've got to thin down some cut outs that I am applying to a project (they are little teddy bears).

My first thought was to stick them to a "backer" board with double sided carpet tape and then run them through my planer. I could also cut some squares into some scrap wood and mount them on a backer board, place the bears in the squares and do the tape thing also. I suppose I could also try mounting them in the frame and resawing them, but I'd still have to sand them.

Pros and Cons? Any other methods? TIA.

Re: Planing cut-outs

#2

Re: Planing cut-outs *LINK*

JohnKJordan in East TN

>JL,

I don't know if this will work for you, but I read where some instrument makers use a fixture with a small drum sander (the type used in a drill press) to feed small pieces for precision thicknessing.


http://www.luthiersfriend.com/

Re: Planing cut-outs

#3

Re: Planing cut-outs

Barry Irby

>I have a lunch box planer and I would be extremely reluctant to run any thing through it that was not held down by at least one of the feed rollers. I MIGHT try short pieces that woud fit under only one roller at a time if I taped them down and then I would want a sled or carrier that had a ledge on it to support the rear end and prevent the knives kicking it out the feed end of the machine. Stay out of the line of fire in front and back of the machine. You could hot glue them to a carrier and then use heat to release them, but I woudl still stay out of the way.

I have a Perfomax and would use that but even that is problematic. I would use a carrier for small pieces. (The guy I bought it from used it to sand about ten thousand lttle "tulips" for craft shows.)

Re: Planing cut-outs

#4

Looks to me like the perfect job...

Denis Ch�nard, Orl�ans, Ont.

>...for a hand plane...

DC

Re: Planing cut-outs

#5

Re: Planing cut-outs

Doug Turner

>I used a 3 1/2" electric hand planer on a sled to cut 1/8" to 1/4" thick strips for turkey calls. You can also cut tapered sides with this method. I used a woo stop at the front and rear of each strip being planed (unfortunately I didn't take any pictures).

You can also attach a number of strips with hot glue to a backer board and run thru a drum sander.

Re: Planing cut-outs

#6

JL

Re: Pieces are already cut out...

JL

>and I don't want to get a catch on the teddy bears poor arm.