Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

router table fence length

Posts

router table fence length

#1

router table fence length

Bill Houghton, overcast in Sebastopol, CA

>I've got an older Porter-Cable Model 698 router table. The fence on these is terrible, so I'm adapting a fence picked up ($3!) at a garage sale. The fence is a large aluminum angle-iron extrusion, 37" long. P-C router table tops are just under 18" long (by long, I mean the direction I'll move the work across the bit with the fence in place). Due to how I'm connecting the fence to the table (LV T-track screwed to angle stock screw to the edges of the table), the fence will overhang the table 1-2" on each side, at minimum. Is there any benefit to leaving the full 37" length on this fence that's powerful enough to overcome how much more hassle it will be to store it full-length in my tiny shop?

Thanks for ideas, other than "buy a new router table." Due to money (none) and space (very little), this seems like about the right router table for me, if this improved fence design will overcome the worst feature of the table.

OK. Back out to the cold shop to drill aluminum.

Re: router table fence length

#2

Re: router table fence length

Ray Binnicker

>Hey Bill,

I don't think the length of the fence is critical. If you're happy with the table length and a fence that would be longer than that would be a hinderance, I'd cut it off. Looking at some of the set-ups those guys from the "Router Workshop" on the Woodworking Channel use I think confirms the length really don't matter.

Ray Binnicker

Re: router table fence length

#3

Re: router table fence length

George@Colonel's Workshop-Havertown PA

>Good Afternoon Bill,

I agree with Ray. If the fence length proves impractical, cut it to table length.

George

Re: router table fence length

#4

Re: another thought

Glenn Madsen near San Francisco

>Yes, storage is a hassle. But when you build that super router table, with a partial sheet of Borg melamine and a Rockler plate, you'll be glad you didn't cut up your $3 miracle.

I'm a lot happier with the longer fence, BTW. And I can't think of a downside right now. But then, I've been cleaning gutters and leaves...

Re: router table fence length

#5

Re: router table fence length

Derek

>Bill,

Don't cut unless you must. A piece of extrusion with a cutout should not take up much space at all on end.

Long is definitely better.

You may want to spend a few bucks later and make a router table - perhaps a collapsible one or one which can be folded up or one which gets clamped in your bench vise. You can make them out of very inexpensive material like melamine or MDF. You don't even need to buy a mounting plate for it - though that works better, in my opinion.

Re: router table fence length

#6

Re: router table fence length

Danarrowsmith

>Just a thought, but if you cut in half you have 2 fences, and then you can cut one with a smaller and one with a larger opening to suit the bit in use.

Re: router table fence length

#7

Re: router table fence length

Gordon Sampson

>Bill,

Check out an article I wrote about a router table I built many years ago. The article is under Articles & Reviews (BP) and it's called Router Table with Cabinet. I built my fence from plans that came from Woodsmith Magazine with a few modifications. I'm still using it and still love it. Great dust collection and the fence is sturdy and accurate.

Gordon