Re: amount of lumber needed *LINK*
Jack
>Bill
If you want to save a little time and effort with this job this might help. I own a cabinet shop and we have gone completely to 2" face frame stock that we buy from our lumber supplier. It's run through a moulder and is ready to cut to length and build the frames. They keep oak, NSM, cherry, poplar, and hickory on hand. They'll run whatever you want for a slight upcharge. It sounds a little pricey when you first get the numbers but there's virtually no waste and it's fast. Also, the lumber is usually very clear, straight grained and from the same run. Very little grain and color matching necessary. I pay the following in MS: .78-red oak, .99 NSM, 1.30 cherry, .78 poplar, 1.09 hickory. I'm sure you have a lumber yard in your area that supplies the same product. Many shops have gone to it.
I use a cabinet design program called Cabinet Solutions that has almost no learning curve. I was drawing cabinets in 30 minutes. They have a 2 week free trial version that gives you full use of the program to inlcude graphics and cut lists. It tells you to the inch how much frame stock you'll need as well as plywood requirements, optomizing, assembly schedules etc. It provides a door and drawer front list also. I would think you could get everything you'd need from the program in two weeks. BTW, It costs around $3K to buy it or you can lease it for $100 per month.
Good luck
Jack
Cabinet Solutions