Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

After much trial and tribulation (mounting issue) *LINK*

Posts

After much trial and tribulation (mounting issue) *LINK*

#1

After much trial and tribulation (mounting issue) *LINK*

Mike Schwing from Maryland

>After way too much thinking on the subject, I came up with a satisfying way to mount two very delicate, tall carvings I recently produced. Magnets! However, I should have probably thought it out a little more, for it never dawned on me to sink the magnets and then fill the holes with mahogany plugs. Next time I guess. The really nice thing about it is the gallery owner was very pleasantly surprised at how they came off of the mounting and later told me they'd been sold the same afternoon as displayed.

I was able to find tiny little 1/16" magnets to embed in the spoons and used 1/4" magnets on the sides. They came from a company linked below the photos. Comments welcomed!


img

Rare Earth Magnets

Re: After much trial and tribulation (mounting issue) *LINK*

#2

Re: After much trial and tribulation (mounting iss

Barry Irby

>Really Cool. I like both the spoons and the carvings.

May I suggest>>>> Next time, drill a hole in the back of the panel with a forstner bit and insert the magnet form the back. Not actually sure about this. It would make the magnets invisible, but it would leave no reference or registration about where to put the sculptures when you put them back. Neat idea though, sculpture you can handle. You could sculpt out a recess in the panel, but that might make the panel more difficult to make than the sculpture itself.

Re: After much trial and tribulation (mounting issue) *LINK*

#3

Re: After much trial and tribulation (mounting iss

Mike Schwing from Maryland

>I like your idea even better. Might be hard to locate though with no reference marks! Thanks for the comments and the idea.

Re: After much trial and tribulation (mounting issue) *LINK*

#4

Re: After much trial and tribulation (mounting iss

Carol - now in NC Nebraska

>Hey, Mike,

Carve a small indentation for the bowl of the spoon and there is your reference spot! Even something a 1/16" deep, hardly seen, would work.

BTW, nice work.

Re: After much trial and tribulation (mounting issue) *LINK*

#5

Magnets Make The spoons very

George@Colonel's Workshop-Havertown PA

>Attractive, Mike. :<)

George

Re: After much trial and tribulation (mounting issue) *LINK*

#6

Re: After much trial and tribulation (mounting iss

Don in Central Illinois

>Actually drill a hole completly through where you want the magnet to be and then plug the front side with a piece of contrasting wood with the magnet on the back. That would give a visual reference of where the magnet is located.