Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Baby Cradle questions

Posts

Baby Cradle questions

#1

Baby Cradle questions

Barry Irby

>Can somebody give me the approximate dimensions of a swinging baby cradle? I'm talking about the kind that have a stand with a stretcher under the cradle and the cradle hangs from pivots on the up rights.

I want to make two, one for dolls and one for an actual baby. May scale the doll one down a bit. Is there a standard mattress you can buy for these? Where?

Thanks.

Re: Baby Cradle questions

#2

Re: Baby Cradle questions

John E

>I have made several of these over the years, and my reference was always to buy the "mattress" first, and make the cradle to fit. The mattress is usually just a pad about 2" thick, that can be bought at any baby store (Babies R Us), or probably Wal-Mart, etc. I'm sure there is a standard size, but I can't tell you what that is off the top of my head. All the ones I've made have either been given away, or the one I made for my kids has long been in storage, and the mattress was thrown away. So I can't help you with actual measurements.

I will give you one suggestion to consider though - for the pivots on the uprights, I tried several approaches, but finally settled on the metal and plastic pivots Rockler sells for glider rockers - they worked great, and were very easy to install.

HTH,

John

Re: Baby Cradle questions

#3

Re: Baby Cradle questions

Kneale Brownson awaiting snow in N. MI

>I think the most common size for cradle mattresses is 18X36 inches. There are slightly smaller (14-15X32-33) versions available too.

The one I made for our neighbor's first child (now in use for daughter #2) was to fit the 18X36 mattress.

Re: Baby Cradle questions

#4

Re: Baby Cradle questions

George@Colonel's Workshop-Havertown PA

>Good Afternoon Barry,

I sized the cradle on the mattress I bought in advance. General plans came from Shopsmith, but I can't find them unfortunately. I substituted side slats in lieu of spindles, and installed raised panels on the ends, rather than leaving them solid cherry. The wood came from #2 daughter's tree, blown down in a hurricane a couple years ago. I made it on time for the surprise baby shower for #5 Grandson Jason, who is in the pix somewhere. Proud parents are #3 son Ken and his wife Krisie.

George


img

Re: Baby Cradle questions

#5

JL

Re: Baby Cradle questions

JL

>I sized the one I am building for an 18 x 36" mattress.

I made the uprights about 36" tall, though they could be made taller.

My "feet" for the uprights are about 27" wide and I used 5/4 board for the feet and 4/4 for the uprights and cross-support.