Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Plate for Freud FT3000VCE Router

Posts

Plate for Freud FT3000VCE Router

#1

Plate for Freud FT3000VCE Router

tom rex

>I have a Rockler router table top that has an 8 X 11 inch plate hole with 3/8" radius corners and just a little over 1/4" deep for the router plate to slip into.

Where can I purchase a custom-made plate that will fit this router and the hole in my table with the screw holes that attach the router to the plate drilled into the plate?

Could it be made from 1/4 inch hardwood?

Or is there some other way to make the plate?

I do not have metal working tools.

Re: Plate for Freud FT3000VCE Router

#2

Re: Plate for Freud FT3000VCE Router

Glenn Madsen near San Francisco

>Rockler should have a 'blank' plate that you can use, in aluminum. And aluminum cuts with pretty much the same tooling you'd use on hardwood. You just need some drill bits and a countersink, and a drill press or a steady hand with an electric drill.

I have a grandfather of that router now for 6 or 7 years. It's served me well.