Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Math wizards...help

Posts

Math wizards...help

#1

Math wizards...help

DocJim...Fayetteville, NY

>Ground rise (46") over run (175") = ? angle

Re: Math wizards...help

#2

Re: Math wizards...help

Mike Baker

>Answer

14 degrees 47 minutes.

Re: Math wizards...help

#3

Lee Grindinger

Sheesh

Lee Grindinger

>Cripes, 14 minutes for the answer?

Lee

Re: Math wizards...help

#4

Re: Too Fast?

Mark Mandell - Gone Round In Jersey

>After all, he did leave out the "seconds" calculation.

|;-}}

Re: Math wizards...help

#5

Re: Math wizards...help

Don Pierson

>Google the string 60*arctan(46/176)

The reply is 60 * arctan(46 / 176) = 15.3386955

Re: Math wizards...help

#6

Since you said ground rise......

Basil

>.....you must be doing some grade work and as such that would be a 26.3%(percent)slope or roughly a 4&1/2 to 1 slope.

Re: Math wizards...help

#7

OOOOPS..........

Basil

>That'd be a 26.3% grade or roughly a " 3 1/2 to 1 slope ".

Re: Math wizards...help

#8

But why the discrepancies?

doug f, san clemente, ca

>All right, you math whizzes (whizii?). There's several different answers here. The angle is about 15*, no question, but why are there at least three different numbers? I fired up Turbo Cad and got yet a slightly different answer.

Inquiring minds want to know..., or not.

Doug

Re: Math wizards...help

#9

Re: But why the discrepancies?

Dan Donaldson

>Possibly depends on how you enter the numbers and what the precision is for the calculation method. I did it on my calculator, in excel, and in the Google calculator and all came up with 15.2397 degrees rounded to 4 places.

I did it by using arcsin(46/175). In Google and Excel, I multiplied the result by 180/pi because their answers were in Radians.

Re: Math wizards...help

#10

Picking nits here

Tim Greif - West of Chicago

>Dan, the OP stated rise and run. If you used the Sin function, you're calculating wih rise and hypotenuse. Rise and run uses a Tan function. I get 14.7274 as the arctan of 46/175.

Re: Math wizards...help

#11

Re: Picking nits here

Mark Serfas

>Tim is correct. The original question stated rise and run, which are in mathmatical terms the opposite and adjacent sides of the angle in question. How were these numbers for rise and run measured? If they are truly rise/run, then Tim's answer is correct using the arctan function.

arctan(46/175)=14.7274 degrees

arcsin(46/175)=15.2397 degrees

Re: Math wizards...help

#12

OOps

Dan Donaldson

>You are right. CRS moment ;-)

Re: Math wizards...help

#13

Yes.....

Mark Goodall - ATL - tooljunkie

>Yes, if the ground is rising that much, then run.......

Happy Woodworking!

Re: Math wizards...help

#14

I really appreciate a good sense of humor.

Art Silva

>

Re: Math wizards...help

#15

Re: Picking nits here

Mike Baker

>Rise over run is the Tangent function. My answer is the correct one.

RISE OVER RUN IS THE TANGENT FUNCTION>

46 divided by 175= .2628

That is the TANGENT equivelent to 14.72 degrees.

Now that is DECIMAL DEGREES

therefore you multiply .72 times 60=====

43.2,,

and ifs yas wants to get down and dirty then multiply .2 times 60====== 12 therefore the angle==

14 degrees, 43 minutes, 12 seconds.

Mike

Rise over run is the TANGENT function

Re: Math wizards...help

#16

I am with Mike, only off the top of my head,

Keith Newton

>Here is how I would figure this.

A circle with 57 5/15, has a cir of 360, thus one inch along the arc = one degree.

So three time 57.39 ? 172, or pretty close to the 176" of run, so three into the 46, is going to be 15.3.

It took me about 15 seconds to figure that it was just under 15 using this trick.

Once you get the hang of using this formula, it gets easier with practice.

If you have a good memory for numbers, here are some other factors of this. divide the 57.395, by 2, then you use 28 5/8 for the radius, and each 1/2" along the arc will = 1�

Or 14 5/16, each 1/4 ? 1�

or 7 5/32, each 1/8 ? 1�

then finally when you are down to about a 2x4 width, or 3.5" ~ 1/16" out of square is ? to 1�

Re: Math wizards...help

#17

give a man a fish...

JohnKJordan in East TN

>It's helpful not only to know the answer, but how to figure out variations of such problems in the future (as in, "give a man a fish... :).

Draw a right triangle with one point to the left and the 90 deg corner on the right, such that the right side is vertial and the "bottom" is horizontal. (Little picture attached.) The third side of the triangle, the longest side, will slope up hill to the right. The vertical side of the triangle is the "opposite" side, the horizontal side is the "adjacent" side, and the sloped side is the "hypotenuse". (BTW, the terms adjacent and opposite refer to the triangle sides adjacent to the angle and opposite the angle.)

The angle in the forumlas is the angle between the adjacent side and the hypotenuse of the triangle.

To help remember the triangle formulas for sine, cosine, and tangent, there is a simple mnemonic you can use: "oscar had a heap of apples", where the first letter of each word represents the side of the right triangle, i.e.,

...... o=opposite

...... a=adjacent,

...... h=hypotenuse

To remember the formulas, write a fracton with two words of the mnemonic with each function in order, i.e.,

...... sin = oscar / had

...... cos = a / heap

...... tan = of / apples

so,

...... sin(angle) = opposite / hypotenuse

...... cos(angle) = adjacent / hypotenuse

...... tan(angle) = opposite / adjacent

For this problem,

...... vertical height of rise = opposite

...... horizontal length of run = adjacent

...... distance up the hill = hypotenuse

so,

...... tan(angle) = opposite / adjacent

...... tan(angle) = rise / run

Solving for the angle,

...... angle = arctan( rise / run )

If you remember the mnemonic and the order (sin-cos-tan), you can always write down the formulas and figure out a variety of triangle problems.

JKJ


img

Re: Math wizards...help

#18

But, teach a man to fish,...

Clint Searl, at the base of Haycock Mtn

>and he'll sit in a boat and drink beer all day!

Clint

Re: Math wizards...help

#19

Re: give a man a fish...

John in Calgary

>You forgot to put in Mark's guy running in your picture.