Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

OT Open end wrenches

Posts

OT Open end wrenches

#1

OT Open end wrenches

Tom Norton

>Is there such a tool as a "thinner" open end wrench? I need to adjust my planer and it has a jam nut and both wrenches are 5/8" but the bottom nut requires a thinner wrench.

Re: OT Open end wrenches

#2

Re: OT Open end wrenches

Dick Heineman

>I went through the same thing a few years ago and ended up grinding one down to the right thickness on my bench grinder.

Re: OT Open end wrenches

#3

Re: Yes, check out your LBS

Kris Lasure

>Hi Tom -

A stop by the local bicycle shop (LBS) should take of your needs. Wrenches for bicycles are just plate steel around 1/16" thick. Being a cyclist myself, I use my wrenches every once and a while to adjust tools in the shop that require that certain thickness to reach into tight areas. You mentioned 5/8" which is equilavent to 15.875 mm. Most bicycle tools are metric so grab a 16 mm wrench and that should do the trick.

- Kris

Re: OT Open end wrenches

#4

Yes, Tappet wrenches

Bill Hammond, Oregon Coast

>Tappet (sp?) wrenches used to adjust the valve clearance on a camshaft. Sears and auto parts stores sell them.

My Sears wrenches are slightly more than 3/16 while a normal wrench is 5/16 thick.

If you grind down a full size wrench be careful not to loose the temper.

HTH

Bill, on the sunny Oregon coast

Re: OT Open end wrenches

#5

Sears used to make full sets

Ray Thompson - Middletown,IN

>called thin wrenches.

Ray

Re: OT Open end wrenches

#6

Re: Superthins

Kneale Brownson awaiting snow in N. MI

>Tool Warehouse lists an SAE set for around $18 HERE.

Re: OT Open end wrenches

#7

Re: Superthins...whoops

Kneale Brownson awaiting snow in N. MI

>Try THIS

Re: OT Open end wrenches

#8

custom made required for me

Bill Tindall, E.TN

>I bought a thin wrench and it was too weak to unstuck my jam nuts. So I ground, carefully without heating, a regular wrench until it just fit the slot and that worked.