1/2" plug with skeptical 1/2" blade *LINK*
Bill Falberg
>See for yourself. The width of a blade has little to do with its turn radius, but the set sure does! That blade would only do a 3" radius, at best, before I reset it to .124" kerf. Its original kerf was .064"; at which setting it ripped much faster and smoother. My favorite setting for rafter tails is .092" which still turns an 1" radius but not so rough. With deep cuts like this you'd be better off with a 3/8" 3TPI reset which is smoother but takes longer than most folks could download the Megs of this video for; if that makes sense.
Cuttin Plugs



