Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

router & lifter

Posts

router & lifter

#1

router & lifter

tom rex

>I have a Rockler router table with a home made cabinet.

I'm in the market for a new router that will fit in the Rockler router lifter (item 22788) or the JessEm Mast-R-Lift model 143613 or 143614).

I was looking at the Porter Cable 690 LRVS.

Which of the lifters would you recommend?

Which router would you recommend?

Thanks for your recommendations,

Tom

Re: router & lifter

#2

Re: router & lifter

Patrick Schupbach

>I would recomend the PC 7518. This router will take just about anything you throw at it. Not sure which lift to go with, they are similar.

Re: router & lifter

#3

Re: router & lifter

Larry Clinton

>Depends on what you are going to use it for, if you intend to do frame and panel I would go with a more powerful router PC 7518 is a good choice. You need two things to swing the larger diameter bits, power and variable speed control. As far as router lifts I can't comment. I have a PC 7539 plunge router on my table with a "Router Raizer". This works very well for me, total cost was about a little less than the 7518 plus one of the other router lifts.

Re: router & lifter

#4

JL

Re: router & lifter

JL

>Depends what you are going to do. The PC 7500 series is a nice hefty 3 1/4 HP router. The PC 890 series runs about 2 1/4 hp. The PC 690 series runs about 1 3/4 hp. If you plan on running larger diameter or heftier bits, you will need a heftier router than the PC 690 series. At the minimum, an 890 series router. I've got two 890 series routers. I wouldn't mind have one of the 7500 series in my table.

Re: router & lifter

#5

See my Guide at the Link *LINK*

Garrett in Victoria

>I recently posted an installation guide - see link below - for the MastRlift (the Rockler is the same unit in blue rather than red) that also includes comments on the other routers that will fit it.

The two big ones - 15 amps - are the Porter Cable 7518 and 7519 which just drop in as is, and the Milwaukee 5625 which JessEm seems to show in their promo photos, but which requires a shim kit made by JessEm. The PC 7518 and Milwaukee 5625 have variable speed which is important, the PC 7519 does not.

The smaller PC 690 series and other similar round body routers such as the Bosch can also be used with a JessEm adapter. (My post shows the 690 with adaptor).

However, if you're buying a new router for the lift, it seems to me that the only way to go is the PC 7518, since that's the router the lift was designed to take, and the price differential after you add in the adapters isn't significant over the many years you'll probably use the combo.

Cheers, Garrett


MastRlift & Router Types

Re: router & lifter

#6

Re: See my Guide at the Link

George@Colonel's Workshop-Havertown PA

>Good Morning Garret,

I pulled the trigger at Amazon for that set up this morning. And for Tom: I also recommend the P+C 7518. I've had mine for a few years. It cost an arm and a leg, but well worth the expence over time.

George