Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Construction lumber moisture content

Posts

Construction lumber moisture content

#1

Construction lumber moisture content

Lee Schierer - McKean, PA

>For you professional carpenters adn contractors. I am reviewing a specification for a construction project where lumber framing may be involved. What is considered to be the acceptable maximum moisture content for construction lumber for framing by the construction industry? Cabniet makers normally want wood at 7-9% MC but I don't know what is standard for construction specifications.

Is it the same for plywood? Does treted lumber have a different MC level than softwood untreated lumber?

Thanks,

Lee

Re: Construction lumber moisture content

#2

I believe 15% to 18% MC out of the kiln is std.

Art Silva

>Go to the Forest Products Lab website for the complete scoop.

Re: Construction lumber moisture content

#3

Re: Construction lumber moisture content

Thomas Skaggs, Foothills of Mount Level

>Lee,

There is the "should be" moisture content and then there is reality! The moisture content of construction lumber is ridiculous. I've heard tons of stories of studs twisting in walls of new homes.

A new local nursing home was opened over a year late due to nasty mold problems throughout the facility. The culprit was wet lumber in the walls. The project lost millions fixing the problem and decontaminating the entire facilty.

Buyer beware!

Tom

Re: Construction lumber moisture content

#4

Lee Grindinger

For construction lumber there are different rules

Lee Grindinger

>S-Dry means surface dry which is 18% or below. S-Grn means surface green which is 19% or greater. KD means surface dry which is the point at which surface moulds won't grow, 18% or below.

For spec-ing construction lumber use KD or S-Dry as decent building material. There will still be significant moisture loss but the industry is against you on this, accept it.

As to species, Hem is hemlock, DFir is douglas fir, and SPF is a grouping into which spruce, pine and fir are lumped. Doug Fir is the best of them from a structural point of view being the best choice for rafters, joists and beams. SPF can be speced for studs and such where the strength to size issue is not critical.

Lee

Re: Construction lumber moisture content

#5

Jason Roehl in Lafayette, IN

Re: Construction lumber moisture content

Jason Roehl in Lafayette, IN

>Treated lumber definitely can have a higher MC. I don't know any specs on it, but I have squeezed liquid out of a PT board when I tightened down a bolt. I've never had that happen with a non-treated piece of lumber.

At the end of the day, I don't think MC matters much in construction lumber. You can protect it and keep it under 19% up until the job site, but inevitably, it will be exposed to rain or snow before it is fully enclosed. The best thing you can do is get it closed up and conditioned as soon as practicable. Getting the roofing and siding on sooner rather than later seem to help from what I've seen--they'll keep new moisture out, and allow you to take steps to remove what is inside by heating, A/C or dehumidification.

From lumber and concrete to drywall mud and paint, there's a fair amount of moisture that goes into a new construction structure. It has to come out sometime...

Jason