Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Router in Unisaw extension table on mobile base

Posts

Router in Unisaw extension table on mobile base

#1

Router in Unisaw extension table on mobile base

Bill H-Evansville, IN

>I would like to install a router in the extension table of my Unisaw on a Delta mobile base. The legs are located in from the corners so it would seem one of them would be right in front of the router. Also, the standard table board has a reinforcement right where the insert should go. It seems that it would be awkward to access the router from the front of the saw past the fence. I'm sure others have done this. Did you just move the reinforcement? Is it troublesome to work around the table legs? Should I just plan to access the router and work from the back of the saw for routing work? Hope you have some advice.

Thanks in advance,

Bill

Re: Router in Unisaw extension table on mobile base

#2

Re: Router in Unisaw extension table on mobile bas

marc rosen

>Hello Bill,

When I got my Unisaw I had the same thoughts but I was persuaded not to by the salesman and a Delta rep because they said the table material (Biesemeyer fence system)was not stiff enough to support a router plate insert. They said I could do it if I laminated a sheet of plywood underneath. I decided to build a separate router table and built storage shelves underneath my Uni said table.

Don't get discouraged, it can be done but I did not want to bother with building up the table top from the underside.

I used to have my Craftsman table saw with a router on the side table but that was a homemade table made from a 1960's era kitchen countertop. Strong enough to support a horse.

Marc

Re: Router in Unisaw extension table on mobile base

#3

I did it.....

Mark Goodall - ATL - tooljunkie

>I had a router in my extension table (Delta cotnractor) until I realize whata PITA is was to use.... switching back and forth between the tablesaw and the router and the fences settings and all that.

Happy Woodworking!

Re: Router in Unisaw extension table on mobile base

#4

Paul Kramer

Check your E-mail

Paul Kramer

>