Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Need a flute cutter router bit

Posts

Need a flute cutter router bit

#1

Need a flute cutter router bit

Brian in Brighton

>I am looking for a 1/4 inch flute cutter that can cut the side of a piece. I am making some corbels and need to cut the flute along the curved front face, so a simple core bit will not work. I found one from Eagle, but it is not a safety flute cutter and I had no luck finding others selling the same thing. I was not hoping to buy a 1/4 3-wing slot cutter and then have to have it ground down, but will if that is the only course.

Any suggestions?

Brian in Brighton

Re: Need a flute cutter router bit

#2

Why have the third flute ground off???

Ron Hildreth, Alta, Iowa

>

Re: Need a flute cutter router bit

#3

Re: Why have the third flute ground off???

Barry Irby

>Ron, I think he means to have the cutter reground or sharpened to cut a round bottom groove rather than a flat bottom groove. My slot cutter cut "parallel" to the base of the router, as opposed to a core box cutter that cuts "Perpendicular" to the base of the router. The sot cutter would allow him to cut a round bottom groove that follows a profile of the edge that you could not follow if the base were resting on that surface.

Re: Need a flute cutter router bit

#4

Re: Need a flute cutter router bit

Charles M

>Is this (Freud item 99-029) what you're after?:

Charles M

Freud America, Inc.


img

Re: Need a flute cutter router bit

#5

Re: Why have the third flute ground off???

Ron Hildreth, Alta, Iowa

>Thanks, Barry-- that one went right over my head without a sound! NOW I know what Brian wants! Shoulda seen that one commin! Sorry, don't have one anyway!

Ron in Iowa

Re: Need a flute cutter router bit

#6

Re: BINGO-WE HAVE A WINNER

Brian in Brighton

>Now, where can I find one? Can I order it online from a WC link?

Brian in Brighton

Re: Need a flute cutter router bit

#7

Re: Quick Question

Brian in Brighton

>Does Freud sell the cutter that is interchangable with this one? I double checked and actually need a 3/16 radius, but would like to buy the 1/8 radius cutter if it is interchangeable like slot cutters.

Brian in Brighton

Re: Need a flute cutter router bit

#8

Is this what you need?  *LINK*

Bob Entwisle in NJ

>


http://www.routerbits.com/cgi-routerbits/sr.cgi?1194239014_15068+54

Re: Need a flute cutter router bit

#9

Re: Quick Question *LINK*

Charles M

>The cutters are not interchangeable but we also offer the 99-030 which is 3/16" radius (3/8" wide groove). Check out the Google search link below for lots of sources.

Charles M

Freud America, Inc.


img

Freud 99-030 Google Results