Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

A nice chat with Glen Huey!!!!!!

Posts

A nice chat with Glen Huey!!!!!!

#1

A nice chat with Glen Huey!!!!!!

lee beeden

>I started building this small 'Martha's Vineyard' cabinet from one of Glen Huey's books. Its a beautiful piece, Glen always has such an eye for proportions!!!.

Everything was going just fine until it came to the final cove molding.

The final piece asks for a 7/8 radius on to 1" x 1" stock.

I searched high and low for a router bit that would do this but to no avail. I had tried cove moldings on the table saw before but on much wider stock. Stumped I decided to check out Glen Huey's website hoping for some possible hint at how this was created.

Of course there was nothing, except for a contact number. Feeling a little shy I left a detailed message explaining my dilemma and headed out to the shop.

On my return there was a message from the man himself explaining the complete process, and also telling me to phone him as he will be in all evening and would be delighted to help.

I phoned Glen and had a great chat! What a gentleman. He further explained the process in detail and asked for my e-mail. The next morning there was an e-mail with an attached diagram of the process and a request for me to send pictures of work i had done.

Thanks Glen!!!!

Lee


img

Re: A nice chat with Glen Huey!!!!!!

#2

Re: A nice chat with Glen Huey!!!!!! 

lee beeden

>


img

Re: A nice chat with Glen Huey!!!!!!

#3

Re: A nice chat with Glen Huey!!!!!!

Joe in a Cleveland suburb

>That's pretty neat Lee. Cabinet looks great too.

Re: A nice chat with Glen Huey!!!!!!

#4

Re: A nice chat with Glen Huey!!!!!!

Kneale Brownson awaiting snow in N. MI

>So, how did you make the molding?

Re: A nice chat with Glen Huey!!!!!!

#5

Jim in Burlington Ont.

Nice work

Jim in Burlington On

>I like Glen's stuff alot. Very nice cabinet.

Re: A nice chat with Glen Huey!!!!!!

#6

So this is how Imade the molding!!

lee beeden

>First start with a wider peice of stock, 3" in this case worked good. To my surprise this small of a cove molding can be cut on the table saw.

Then its a matter of trial and error setting up the angle of approach to the blade.

Glen had a good tip for checking the radius on the stock, use a forstner bit until it matches.

Once the angle is determined record this with your sliding bevel gauge off the front of the table saw and transfer to a small piece of plywood, label and nail to the wall( for future reference ).

From here on its just like cutting regular cove molding. Its a little tricky to cut the 45 degree bevels on such tiny stock. Also I found that feather boards were a must!!!

thanks

Lee


img

Re: A nice chat with Glen Huey!!!!!!

#7

What, no birdseye?

Martin from Granbury

>Seriously, excellent work.

This cabinet is on my list of things to build. I will try to find enough birdseye, like he did on the original.

Thanks for posting the "how to" on the molding.

Very nicely done all around.