Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Need information on Boyce Crane motor pulley

Posts

Need information on Boyce Crane motor pulley

#1

Need information on Boyce Crane motor pulley

Wayne

>I own a Boyce Crane table saw and would like to replace the pulley on the motor. The motor is fixed to the base and when I tilt the blade the pulley slides back and forth on ball bearings on a shaft. I don't remember seeing this setup on any other motors so don't know what it is called or where to locate one.

Re: Need information on Boyce Crane motor pulley

#2

Ellis Walentine

Try looking here...  *LINK*

Ellis Walentine

>


OWWM

Re: Need information on Boyce Crane motor pulley

#3

Re: Need information on Boyce Crane motor pulley

Mike Baker

>I had a Boyce Crane saw that had that same slip pully you described.

I sold that saw to a friend, and it now sits in a garage across the street from me!

I still get the opportunity to hear and see that great old saw run!

Gothemburg is no longer a good place to get parts for those saws. The old man died, and his wife made a valant effort to keep the bussiness going. Last I heard it is no longer.

I am a Machinist by trade, and I took the motor shaft, that has bearing grroves ground in it, and found they were still in pretty decent shape. I took the pully apart, and found the small ball bearings had worn. I polished the bearing grooves on the shaft, using turned pieces of brass that were the correct diameter, and lapping compound. \

I then ordered some new steel ball bearings from McMaster Carr. (I miced the old ones and found the same diameter still available).

I reassembled everything and its still working smooth and quiet today. This all happened over ten years ago.

Im sure you could take the assembly to a machine shop and they could help you out with this.

Good luck

Mike

Re: Need information on Boyce Crane motor pulley

#4

Re: Need information on Boyce Crane motor pulley

Wayne Carson "TX"

>My main problem is that the pully doesn't slide like it should, kind of rough. I will try the polishing of the shaft and see if I can get bearings.

Thanks

Re: Need information on Boyce Crane motor pulley

#5

Re: Try looking here...

Wayne Carson "TX"

>Thanks for the link I have been there before that is how I found out what model machine I had.

Thanks