lamb's tongue?
JohnKJordan in East TN
>I found a reference to lamb's tongue and it seemed to be a treatment on the end of a beveled edge. Is that correct? If so, you can do that with Sketchup. I couldn't quite see the detail in the reference I found, so I made a simple curve at the end of a bevel but the same techinique could make any profile.
I used what Sketchup refers to as "intersect with model", a type of operation referred to as booleans in other packages. I created an extruded square for the piece, then created a second piece by drawing the desired profile then extruding. Rotate the extruded profile, intersect, then delete the unused pieces.
BTW, Sketchup's inplemention of boolean is clunkier than most but it still works. Perhaps it is different in a later version, but I quit upgrading when I retired.
If this is close to what you want to do and need more info, just ask and I'd be glad to do a step-by-step example.
JKJ
(Note: I make no claim to expertise with Sketchup, so there may be better ways to do the same thing.)
