Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Jack Rabbit Drill & Drive Bits

Posts

Jack Rabbit Drill & Drive Bits

#1

Jack Rabbit Drill & Drive Bits

awh

>Anyone use these?

I just purchased the 4-bit set and didn't look closely at them until I got them home and noticed that they use the following drill/screw size combinations:

#6 - 7/64"

#8 - 1/8"

#10 - 9/64"

#12 - 5/32"

Is the drill bit meant to be a pilot hole or a shank hole? Because none of the screw charts I have even come close to matching these sizes for pilot or shank holes.

Comparing it against what I believe is a pretty standard screw chart, using the dill bit as the pilot hole in hardwood would result in these screw sizes:

#10 - 7/64"

#12 - 1/8"

#14 - 9/64"

#16 - 5/32"

Or if using the drill bit as the shank hole it corresponds to these screw sizes:

#4 - 7/64"

#5 - 1/8"

#6 - 9/64"

#7 - 5/32"

I feel I�m overlooking something basic here.



Tony Haukap

Home Page - http://www.cyberspace.org/~awh/

--