Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

OT Electrical Question

Posts

OT Electrical Question

#1

OT Electrical Question

Martin from Granbury

>So, there I was, changing a bulb in my ceiling fan. I was trying to be a good conservationist, and I was replacing the burned out bulb with a new "energy efficient" compact fluorescent bulb that costs $7 a pop.

So, I unscrew the dead bulb, or at least I thought I was, when I hear a pop, see a spark, and the other three bulbs go out. I know, I know, I should have had the power off to change the bulb, but that's water under the bridge at this point. Besides, the room would have been a little dark.

Instead of unscrewing the bulb, I somehow twisted the glass part of the bulb out of the metal socket. So, now I had the socket part stuck in the lamp. I took the precaution of turning off the breaker, and then removed the stuck part with needle nose pliars. This is not the first time I have experienced this. I wonder if the bulbs were cheap and break easy. Anyway, I put in the new bulb, turned on the breaker, and turned on the switch. Nothing. Still very dark in the room.

So....did I fry the lamp portion of my ceiling fan? (Fan works fine, BTW, thanks for asking.) If so, how can I prove this without buying a new lamp portion? Note to all the helpful readers: I am an electrical idiot, so please speak slowly and in simple terms.

Thanks guys (and gals) I know I can count on you.

Martin

Re: OT Electrical Question

#2

Re: OT Electrical Question

Steve Mackay

>I too, am only the clan Mr. Fix-it. Not a electrical ennggineer ( can't spell it either ). You should be able to remove a couple screws around the outside of the " lamp " houseing and drop the cover. Check all the wires, wire nuts and the sockets from that side. If something Mr. Fix-it has burned loose you'll see it. If something burned loose remove the wire nut, cut out the burned part and re-connect and replace . . . yadda, yadda. If the fans working there really is'nt all that much to go wrong from there down. Only other thing is the switch. Easy stuff ! $2.00 at HD. Of course I'm saying all this assuming you don't have a multimeter. And yes, the wall switch ( OUCH ! ) doesn't allways (OUCH!) cut the neutral (OUCH !).

Re: OT Electrical Question

#3

Re: OT Electrical Question

Gary Evans Tallassee, TN

>Hi Martin,

Check your breaker box. Chances are that you popped the breaker on that circuit when the bulb shorted out as it came apart.

Gary

Re: OT Electrical Question

#4

Re: OT Electrical Question

Kent in Emmaus, PA

>The short circuit created by the broken bulb fried something. If it's a simple switch-controlled fan, you probably just have a burned wire-nut connection. If the fan has remote control, or a lamp dimmer, it could be damage to an electronic component.

BTW, make sure the fluorescent bulb you're installing is intended for fan use.