Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Walnut Crotch Slabs

Posts

Walnut Crotch Slabs

#1

Walnut Crotch Slabs

Brad in Ottawa

>I might have a line on some just cut Walnut Crotch slabs that are 16/4 thick. Beautiful figure, colour and some live edges. I realise they will take a few years to dry out before I can use them though.

I generally, okay never, have a use for stock that thick. Could these eventually be resawn into 4/4 stock for cabinetry or will this result in severe warping?

Thanks

Brad

Re: Walnut Crotch Slabs

#2

Re: Walnut Crotch Slabs

Rob Sandow

>If you resaw them while they are still wet and properly stack and sticker them then you should be OK. I wouldn't wait until they dried and then try to saw them. Sounds like you could probably make some nice veneer out of them too.

R

Re: Walnut Crotch Slabs

#3

Re: Walnut Crotch Slabs

Thomas S Stockton

>Walnut seems to be one of the easier woods to dry. If you could get them milled in half into 8/4 that would dry quicker and still stay flat. 4/4 has more of a tendancy to warp and 8/4 is useful for legs and stuff like that. Otherwise let the thick stuff sit a while.

Tom

Re: Walnut Crotch Slabs

#4

Re: Walnut Crotch Slabs

Tom Sontag - St. Louis

>If you know you want to use these as 4/4 panels at some time, it would be best to resaw them before drying IMO. That means maybe 1 1/8" thick rough. Even though walnut is easier to dry than most, crotch slabs are always difficult. the problem is not warping (since the best pieces are really QS material) so much as checking. You must coat each crotch face with something to slow down the drying to avoid checking, especially the sappy area at the top of the crotch since this is essentially end grain. Of course also coat the ends.

In summary, because you must dry these very slowly, if you want to use them in your lifetime, resaw before drying is best.

Re: Walnut Crotch Slabs

#5

Re: Walnut Crotch Slabs

Don in Central Illinois

>As a turner lurking on the flat side, use them for platter or shallow bowl blanks.

Re: Walnut Crotch Slabs

#6

Re: Walnut Crotch Slabs

Thomas Skaggs, Foothills of Mount Level

>I agree with Tom. Walnut crotch slabs have a real tendency to crack. Seal them and dry them slowly.

T.

Re: Walnut Crotch Slabs

#7

Hey Brad, got more of these?

Denis Ch�nard, Orl�ans, Ont.

>I would be interested... How big are they?

I agree that you should resaw them in accordance to the thickness of intended use (plus a loss factor). Thinner boards will experience less stress and be less prone to check.

DC

Re: Walnut Crotch Slabs

#8

One thing

Dan Donaldson

>Crotch material cut into lumber is probably not going to be very strong or stable in the long run. You may be better off figuring to use it for veneers, or at least having very good support and not having it be load bearing.

Re: Walnut Crotch Slabs

#9

Thanks All!

Brad in Ottawa

>I am following your advice and will let you know how it turns out years from now!

Brad