Re: wood movement by species chart? *LINK*
JohnKJordan in East TN
>Michael,
>chart...movement...kiln dried...
The table on pg 117 in Hoadley's "Understanding Wood" has the tangential and radial shrinkages for many species. The spreadsheet in the link below has the same info but for more species. While the table refers to green-to-oven dry, the way I read Hoadley, (estimation of) the movement you mention is calculated (pgs 118-122) based on this table and on the delta-MC, regardless of how the wood is dried, i.e., by kiln or otherwise. (The MC is everything, regardless of how it got there.) For a more accurate forumla for partially dry wood, note the box at the bottom of pg 120.
The Wood.xls spreadsheet from Oregon State University Extension (link) is one of the best I've seen for data and calculations. It should be possible to compare the species you mention. The dimensional calculations appear to use the more accurate formula. Another thing - all these calculations assume a FSP (fiber saturation point) of 30% where Hoadley assumes 28%. (And don't forget that MC and shrinkage depend on temperature as well as RH.)
If you want to make your own spreadsheet for a custom table, to save a lot of typing I suspect you can start with the data files that Lary Marker includes (JL's link). They should import nicely into Excel.
>average relationaship...
Between tangential and linear? By linear do you mean along the grain (longitudinal)? I haven't seen a table of comparing longitudinal shrinkage by species, perhaps due to what Hoadley implies (top of pg 117) that the 0.1% (green-to-oven dry) is typical for all woods. You could run the same dimensional calculations for that orientation. The 8.6% you mention comes directly from the species table in the N. Red Oak entry.
Another thing not always clarified in various calculators and tables - for our convenience wood can vary a lot from tree to tree even within the same species. For more fun, consider that in the real world a given board might have a combination of radial and tangential shrinkage across it's width. I like what Larry Marker says in his "A Word on Accuracy" (in JL's link) about not being fooled by computations to three decimal places!
JKJ
wood.xls, Oregon State Univ Ext