Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Turning Mulberry Wood

Posts

Turning Mulberry Wood

#1

Turning Mulberry Wood

Jon Browning

>Hello all,

I have started to turn wood recently in the last year. Some time ago I needed to have a tree cut down in my yard. It was a Mulberry. I had the tree guy saw off some rounds from one of the large branches. I figured to rip it into square pieces. I let these dry for about a year in my basement. Recently picked one up. Ran it through my small band saw and it ripped fairly easily. Got it on the lathe and it was so hard it would just catch and bind the motor. I have a Jet lathe with a half HP motor. Most things turn fine.

My question is, is all Mulberry too hard to turn? Should it be turned when green?

Thanks for any help and responses

Jon

Re: Turning Mulberry Wood

#2

Ellis Walentine

Mulberry is wonderful to turn

Ellis Walentine

>You'll get more answers on our turning forum, John, but I can tell you from experience that mulberrry is great turning wood. Its ring-porous structure is much like ash, and its hardness is not extreme, certainly not compared with some of the exotic woods that people turn. If it is stalling your lathe, the best defense is to take lighter cuts.

Regarding dry vs green turning, I always prefer the latter, at least for roughing out a form. That limits the amount of turning of dry wood that is necessary to finish the piece. Wood turned when dry also stays round, whereas wood that is turned green to finish will deform to a more oval shape after it dries. I kinda like that effect myself, but a lot of people prefer round.

Ellis Walentine, Host

Re: Turning Mulberry Wood

#3

Re: Mulberry is wonderful to turn

Barry Irby

>As usual, Ellis is right. Post on the Turning forum and get more answers. Mulberry is not particularly hard of difficult to turn, at least in my limited experience with it. You need sharper tools, lighter cuts, or a larger motor on your lathe, or all three. The lathe is adequate, but will require a light and deft touch.

Turning the wood green is a technique in itself and green wood cuts/turns much easier that dry wood in any given species. The warping is something you either like or don't like. You can "turn to finish" a green piece of wood and completely finish it and then let it warp. Or you can rough out a blank, leaving it thick and "return" it after it is dry. Much less chance of losing a turned blank to cracking that losing blocks. Once turned again dry the bowls will stay much more nearly round and have that "perfect" form.

Re: Turning Mulberry Wood

#4

ellis, iagree

robert davis

>

Re: Turning Mulberry Wood

#5

Re: Turning Mulberry Wood

JohnKJordan in East TN

>I agree with others, mulberry is great to turn. I cut some trees a few months ago while clearing for a new horse pen and made several things on the lathe. I'm anxious to try turning mulberry root from where I dug up the stumps.

I found mulberry hard and dense but turned smoothly and left a great surface, about like dogwood. If you are used to turning softer woods, you may need to use sharper tools or different tools. Open a discussion on the Turning forum and I'll bet you'll get lots of response.

JKJ