Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

T-Bar ceiling question

Posts

T-Bar ceiling question

#1

T-Bar ceiling question

Terry in Edmonton

>I am installing a T-Bar ceiling in my basement and I am trying to find out what the minimum clearance between the joists and the tiles is. Neither the supplier nor the manufacurers web site could supply that info. Any information would be very much appriciated.

Re: T-Bar ceiling question

#2

Re: T-Bar ceiling question

Kneale Brownson in sunny N. MI

>I don't have a figure, but you can expect to need at least three or four times the thickness of your tiles to give you room to maneuver them in and out, I'd think. Hang a couple sections and see what you need to manipulate the tiles.

Re: T-Bar ceiling question

#3

JL

Re: T-Bar ceiling question

JL

>I am presuming that you mean "suspended" ceiling on grids when you mean "T-bar". As Kneale said, at least 4-5 ceiling tile widths (or depths). I've done suspended ceilings with as little as 2-3" between the track and the joists - it is no fun trying to get the tiles up there. If you have a "sculpted" panel, it usually takes more clearance. If you have a "regular" panel without any fancy edges or sculpting, it can take less clearance.

If you can, try for at least 4-5" between the top of the track and the bottom of the joists. My $0.02.

Re: T-Bar ceiling question

#4

Re: T-Bar ceiling question

John E

>Don't think there is a "minimum" - just the minimum you need to be able to install the tiles. I recently did a dropped ceiling using 2x2 tiles, and I used 5 1/2" clearance, which worked fairly well. If you're putting the fluorescent lights (the kind that that take up a 2x4' space), you would be hard pressed to install them with any less clearance. Otherwise, you could probably get by with about 4 inches, but I don't think I'd try any smaller than that.

My 2 cents.

John

Re: T-Bar ceiling question

#5

Re: T-Bar ceiling question

Ron Hildreth, Alta, Iowa

>Terry,

Check your local building codes, as yours might be different than others. If there is no code for such in your area, I would think you could put it up as tight as you can and still be able to get the tiles in and above the T-bar railings. Just be sure you stay away from things like hot furnace and water heater chimineys, etc.

Ron in Iowa

Re: T-Bar ceiling question

#6

Re: T-Bar ceiling question

RK in Milwaukee

>I Googled the question, "How to install a suspended ceiling" and the answer is 4 inches if you are NOT installing flourescent light fixtures and 6 inch clearance if you are installing the light fixtures.

By asking the question on a Google search you get all kinds of installation tutorials.

Hope this helps.

Ron Nelson

Re: T-Bar ceiling question

#7

Re: T-Bar ceiling question

Steven Mellott

>If you are putting lights in the ceiling grid, you need at least 3" between the top of the light and the insulation in the ceiling joists. My lighting fixtures were 3" deep so my ceiling was dropped a total of 6". If you are not putting lights in, I don't think there is a minimum.