Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Kudos to Popular Woodworking!

Posts

Kudos to Popular Woodworking!

#1

Kudos to Popular Woodworking!

Denis Ch�nard, Orl�ans, Ont.

>Marc Adams' article (in the November issue first of a series) on safety is a long overdue topic to be published. Congratulations to Popular Woodworking to bring this issue to the forefront!

DC

Re: Kudos to Popular Woodworking!

#2

more thoughts on the mattter

Bill Tindall, E.TN

>I thought the whole issue was exceptional. Just when I consider not renewing along comes an issue like this one. But, did you ever see anyone look more awkward than the person ripping on the table saw, pg 38?

I did note that, unlike some here on WC, he advocated not sticking the blade much above that to be cut- laceration vs amputation. Also note that on pg 38 the blade barely pokes above the board. Always made sense to me.

Re: Kudos to Popular Woodworking!

#3

Clear the gullit and tails first

Dustmaker Mike

>That is what I say. Put the blade high enough to clear the gullit and when makeing Dovetails always cut the tails first(-;

Really I bring the blade high enough to clear the gullit but not much higher then that. So is this a bad idea?

I have not seen the issue of PW yet, I may buy it to read on my way to South Africa on Friday and see what else I may learn.

No Fishing trip this year I am going on a Safari.

Re: Kudos to Popular Woodworking!

#4

Re: Kudos to Popular Woodworking!

Ken Oakley-Sunny St. Cloud, Fla.

>As far back as Junior high school,(1944-1946), I have been told and practiced having the blade no higher then needed to cut through the material. Works for me because now as I enter my 76th year on this earth I still possess every last bit of all ten fingers for which many of my girlfriends past and present are very thankful for.

Re: Kudos to Popular Woodworking!

#5

Dale Lenz

Re: Clear the gullet and tails first

Dale Lenz

>***Really I bring the blade high enough to clear the gullet but not much higher then that. So is this a bad idea?***

I have always "heard/read" for the saw to cut through the wood most efficiently is to have the saw's gullet level with the top of the board being sawed.

My safety rule is to have the blade half the thickness of my fingers above the board, just in case, ;").

Re: Kudos to Popular Woodworking!

#6

The higher the blade......

Clint Searl, at the base of Haycock Mtn

>the lower the kickback force and rotational resistance.

Clint

Re: Kudos to Popular Woodworking!

#7

Re: Kudos to Popular Woodworking!

Jim Dillon

>Denis,

After scanning my newly arrived issue, I sure agree with you that the content is an excellent choice of stuff. Love that Greene and Greene table by Darrell Peart. And did you notice that Glen Huey did an article on an occasional WoodCentral poster, Rob Millard? His Federal reproductions are truely gorgeous.

Jim