Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Bread Board end questions

Posts

Bread Board end questions

#1

Bread Board end questions

Barry Irby

>My son and I are making a table. The top is two cherry boards that are fifteen inches wide. We took a hint for the recent article in FWW and put a frame around them and left the crack down the middle. The ends of the frames are tenoned onto the sides of the frame and glued. We did not glue the wide boards to the bread boards. So, they are free to float and expand and contract toward the center. My question is: How to keep the finish from soaking into the T & G and gluing the wide boards to the cross grain bread board. Or does it matter. Do not know what he will choose for a finish, but suggestions are welcome.

Re: Bread Board end questions

#2

Re: Bread Board end questions

George@Colonel's Workshop-Havertown PA

>Good Evening Barry,

I've never had a problem with it. Finish which I have applied has been done with a rag and a wipe. I guess finish can seep between cross grained adjacent pieces and dry, causing them to stick together. The pieces are going to move anyway. I don't believe hardened finish is going to cause a split/crack.

George

Re: Bread Board end questions

#3

Re: Bread Board end questions

Jesse in New Mexico

>I have had a problem with that when using very heavy varnish (e.g. Behlen's Rock Hard). No problem with the wood splitting, but the varnish did and made a kinda crusty line where the bread board meets the table panel. If I were going to do it over, I would finish the pieces separately before assembly.

Re: Bread Board end questions

#4

Re: Bread Board end questions

Barry Irby

>Thanks, I had not thought of that. I may take a razor knife and cut the finish in the joint.

Re: Bread Board end questions

#5

Re: Bread Board end questions

Doug Turner

>Barry,

I use a beeswax/mineral oil mixture that is very water replent and easily touched up. This is especially appropriate for cutting boards as the knife edge grooves from cutting blend in when wiped with this mixture. I melt about 8 oz beeswax in a pint of mineral oil over a double boiler and let cool in a storage container where it forms a thick paste.