Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

finish bed before or after assembly

Posts

finish bed before or after assembly

#1

finish bed before or after assembly

Gary

>Ok, so it's been a long time coming, but I'm finally ready to assemble my sons bunk beds! As you can see from the photo, there are 5 head/foot boards, and a guard rail...each has 11 tennons in it...that's right....ugh...lots of mortises/tennons.

Anyway, I do not have any spray equipment, and will be finishing them by hand. I'm thinking that it would be easier to finish before assembly, but I've never done it that way. I've seen an article...somewhere...sometime past, but I didn't pay much attention as I had never done it, and didn't think I would.

So, what do you think...finish first, or assemble first?

Thanks,

Gary

Re: finish bed before or after assembly

#2

photo this time 

Gary

>


img

Re: finish bed before or after assembly

#3

Photo a dry fit?

Charles

>It appears that you have already assembled the HBs & FBs, or is the photo just a dry fit?

Anyway, I would do all of my permanent joinery (i.e, anything that's going to be glued) first, so I have all of my components completed (completely assembled headboards, footboards, rails etc.). Then I would finish each component (HBs, FBs, rails, etc.) BEFORE setting the beds up.

Re: finish bed before or after assembly

#4

Re: Photo a dry fit?

Gary

>Yes, Charles. It is a dry-fit only. Thanks for the input. I have, in the past, always glued first...but considering all the slats, I was considering finishing first....

.......

Re: finish bed before or after assembly

#5

I'm gonna vote for before.....

R. Lance in GR, Michigan

>if for no other reason than this will be a good opportunity for you to try that method...just protect the M/T surfaces from the finish...doing it this way will be more relaxed...you can take your time...you could do a footboard first and then assemble/glue it up before deciding to continue with this method or not.

Re: finish bed before or after assembly

#6

Re: finish bed before or after assembly

Bruce, a MN Galoot

>One year ago, I built a bed for my son that is nearly identical to yours, except there is a flat rail on top of the headboard.

I finished it after glue-up. That included staining and Minwax Antique Oil finish. Were I to do it again, I'd stain the separate parts before glue-up and apply the hard finish afterwards. It's just very hard to keep the timing right - getting to the wiping part before it dried, while at the same time making some progress. I used hide glue, so clean-up was a breeze and wouldn't affect the stain.

The foot board and the rails were finished separately. The slats for the mattress support are unfinished, just sanded very smooth.

Bruce

Re: finish bed before or after assembly

#7

I finished the ones

Dustmaker Mike

>I made before I put it together. I just put tape over the joints so I would not get finish on them.

Re: finish bed before or after assembly

#8

Re: finish bed before or after assembly

Jesse in New Mexico

>I usually finish before assembly. Put some blue tape over the tenons and mortises to avoid getting finish on them. Treat the finished parts gently, when they are dry, place them on a blanket or something to avoid scratches. Use something soft (cardboard) for clamping pads.

Any glue squeeze out should just pop off.

And be prepared for some minor touch up to the finish after assembly.