Woodworking show "The Consumer Woodworking Expo"
Larry Clinton
>I attended the "Consumer Woodworking Expo" at Indianapolis Saturday (returned today but only to exchange a defective Incra tool). Wow, was it a little show. The event was held in the Toyota Pavilion, one of the smaller buildings at the fairground. Basically the exhibitors were the sponsors - Delta/ Porter Cable, Dewalt, Peachtree Woodworking supply, Marc Adams Woodworking School and Apollo Sprayers. Wood magazine is listed as a sponsor and a few stacks of the magazine were available - no booth. The only other booths were Incra and one from a local carving club, manned by one nice gentleman. The Incra people had a nice display / Demo set up, and a small discount on their products - I purchased a Miter 3000SE with a Miter express, bought a couple of replacement leg sets for my Grippers, a couple 50 packs of Mirca sanding discs - did save freight. My son and I went literately looked at every item in the show and were out in less than 2 hours. The Incra Miter was defective (part of the indexing plate was missing) so we had to return today to exchange it - The sales lady did give us a couple of the Tiny T rules for our troubles. As the parking cost $3.00, entry cost is listed at $9.00 (although Coupons are available for $2.00 off, on the web and one came with the card announcing the show). Still, it cost us $17.00 + gas etc. ('bout a 90 mile round trip) to attend. Doubt if we saved any money - the show had less equipment / merchandise showing than either the Rockler or Woodcraft stores in Indy. I was kind of surprised that neither one had a booth at the show. There were not a lot of attendees looking around. I believe this was the smallest show I have ever attended (of any kind).



