Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

The right dado set?

Posts

The right dado set?

#1

The right dado set?

Mark Kozlowski

>I recently acquired a "slightly used" Dimar dado set from Lee Valley at a good discount. When I got it home I realized it was a set optimized for melamine. The two side-cutting blades each have 46 teeth. I have a 1.5 horsepower contractor's saw (Rigid TS 3650) and plan to use the dado set primarily in plywood and mdf. Would I be better off with a more standard set with side-cutting blades that have 24 teeth? Will the 46 tooth blades put too much stress on my 1.5 horsepower motor?

Re: The right dado set?

#2

Re: The right dado set?

Rob Stokes in North Vancouver

>Try it, listen to your motor. You'll know right away.

Rob

Re: The right dado set?

#3

Re: The right dado set?

Don Evans

>There is no rule that says you must do it full depth with one cut that I know of:

Take shallower cuts if necessary.

Don

Re: The right dado set?

#4

Slower feed rate, too

Ron Hildreth, Alta, Iowa

>