Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

electric motor frequency

Posts

electric motor frequency

#1

electric motor frequency

Jean Louis Stutzmann

>I have some single phase machines that can be, or are already wired for 230v.

If I returned to Europe (UK) and used the US made machinery as is, would there be detriment to the motors themselves or their performance due to the slight difference in frequency rating, 50Hz in the UK as opposed to 60Hz here?

If I need to upgrade/adapt, would it mean outfitting with new motors at 50Hz or would there be another possibility?

I would not be using the machines professionally or on a daily basis.

Jean

Re: electric motor frequency

#2

Re: electric motor frequency

Jim Swank

>You could expect the motors in general to run a little more slowly, have a little less power, heat up a little more easily. If you're only doing light use for relatively brief periods, you'll probably be okay. If you want specifics, we may have to talk details of how various types of motors are made, and which types you have.

Re: electric motor frequency

#3

Re: Thank you Jim

Jean Louis Stutzmann

>Your response was much appreciated. Thank you.

With the slightly reduced speed, would it be enough to generate burn marks with hardwoods on the cabinet saw,(3hp), apart from with woods such as cherry which naturally require input care?

With the additional heat build up in the motor, would you know what may be an operational time limit guide for a continuous run when I would be busy with a project before allowing the motor to cool down?

If there are transformers for voltage change can such things exist for frequency change or does electricity not work that way?

Re: electric motor frequency

#4

Re: Thank you Jim

Dan Donaldson

>If the motors were 3 phase, you could just use a VFD, but...

Actually, there are units to change the frequency, but you probably would ot want to pay for one ;-) We used to have a motor/generator where I worked that changed from 60 cycle to 400 cycle, but it wa big and, I am sure, very expensive.

In this case, I wouldn't bother. In most cases, the equipment should work fine for you.

Re: electric motor frequency

#5

Jesper, Denmark

Re: electric motor frequency

Jesper, Denmark

>I did this move some five years ago. The standard motors run fine on 220 Volt 50 Hertz, but 20% slower. It has been OK for the table saw, planer and jointer. The 14" Delta bandsaw also runs fine, but I got a change kit from Agazzani for the larger bandsaw.

In the UK, it is standard practise to run jobsite tools on 115 Volt, so there are transformers easily available. In run my universal motor tools from a 220/115 volt transformer with an installed 115 Volt grid in the shop. They are slowly wearing out and are then replaced with 220 Volt tools.

All in all , it has been no big deal and not expensive either. I did plan to replace 220 volt motors with 3-phase 400 volt, but just never got a round to it.

The fact that2 20 Volt in the USA really is phase to phase and here in Europe it is phase to neutral makes no difference to the tools.

Re: electric motor frequency

#6

Re: Jesper and Dan

Jean Louis Stutzmann

>Helpful information. Thank you.