Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Joint-a-bili-t not straight

Posts

Joint-a-bili-t not straight

#1

Joint-a-bili-t not straight

David Dircksen

>I ran two boards through it and put them together and they wern't straight. I looked at the square tubbing and seen it had a bow in it. Do I take the screws out of the bottom get a new board attach it to the tubbing and straighten it? Thanks

Re: Joint-a-bili-t not straight

#2

Re: Joint-a-bili-t not straight

Dick Coers

>Their sales pitch from the beginning was that this was a matched set edge trimming tool. They always said that the tube did not need to be straight for it to work. If you trim one board on side a, and the other board on side b, both boards may have a slight bow. One board concave, the other convex. That bow should match and the boards join together. Are you cutting this way? I will have to look and see if I can figure out where the screws are. If you want to straighten it out you will have to set some blocks at the ends of the beam and use a clamp pulling against something heavier like a workbench top. Then bring in a new base and screw it to the beam while clamped straight. Add more screws so it will not creep back, or slightly overbend the steel for springback.

Re: Joint-a-bili-t not straight

#3

Bart Goldberg

Re: Joint-a-bili-t not straight

Bart Goldberg

>I used to own the 8 foot one. After a while it started to bow in the middle due to uneven clamping stress across its width. This results from edging smaller boards. I recall flipping the square tubing so that the bend in the middle was pointing downward (like a clamping caul should).

I eventually sold it and bought a Delta DJ-20 jointer. I don't miss the Jointability at all.

Bart