Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Edge miters on left tilt TS

Posts

Edge miters on left tilt TS

#1

Edge miters on left tilt TS

Dan Mitchell

>My new table saw is left tilt. I generally use the left miter slot for crosscutting, but recently cut some edge miters, and it seemed more appropriate from a safety standpoint to use the right slot, so it would be the smaller cutoff bit that was under the tilted blade. Does this actually make a difference?

Dan

Re: Edge miters on left tilt TS

#2

Re: Edge miters on left tilt TS

Ron Hildreth, Alta, Iowa

>Dan, if it feels right to you, then that's what's important! Here again, you're going to get a lot of different opinions, but if it feels comfortable and safe to you, go for it.

My Delta is a right tilt, so I'm always under the blade on most miter edge cuts. But I've rarely had any problem either mentally or physically with making this kind of cut.

Ron in Iowa

Re: Edge miters on left tilt TS

#3

Re: Edge miters on left tilt TS

Dan Mitchell

>Thanks Ron, I was more thinking about the prospect of the larger piece getting trapped/kicked back under the blade, but yeah I guess having it tilt AWAY from ME also has appeal!

Dan

Re: Edge miters on left tilt TS

#4

Beware of the cut off

Lee Schierer - McKean, PA

>On carbide tipped blades, the cutoff piece, particularly if it is small can get hit by the teeth and get jammed(wedged) down into the throat plate. Even a zero clearance insert often probuces a bang and throws pieces around the shop.

Lee

Re: Edge miters on left tilt TS

#5

Re: Beware of the cut off

Dan Mitchell

>Thanks. I have a zero clearance rip insert (non-tilt). Probably would be good to have a 45 deg one too. Is it possible to cut one of those on the saw? Hard to see how.

Dan