Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Carrying sheet goods on a car's roof

Posts

Carrying sheet goods on a car's roof

#1

Carrying sheet goods on a car's roof

Dan Mitchell

>My wife has a Subaru Impreza wagon which has factory roof rails. I would like to use the car's roof to carry 4 x 8 sheets of plywood, particle board, even drywall. I've never done this before, though as a kid I recall my dad having a set of those suction-cup rails which went across the car then were strapped to the drip rail along the roof. We carried plywood on them a time or 2. The existing roof rails run lengthwise on the roof. The manual says you need to add crossbars (the "Genuine Subaru" examples list for $170, though I've seen them for $135 online) then add specific "carrying attachments" to the crossbars in order to carry bikes, surf boards, kayaks etc. Lots of sites seem to show specialized carriers for these recreational uses, but I can't find any that seem to be designed just for sheet goods, long pieces of lumber, and similar items (don't they know WOOD IS a RECREATIONAL ITEM?!? ;-). Maybe just the crossbars would be OK? If anyone can make suggestions on this, also on sources of "generic" crossbars which cost less the ~$170 (some of the aftermarket ones I've seen online are actually HIGHER), I'd appreciate it.

TIA

Dan

Re: Carrying sheet goods on a car's roof

#2

Re: Carrying sheet goods on a car's roof

Tim Caley - North Little Rock

>Just don't do this......


img

Re: Carrying sheet goods on a car's roof

#3

Re: Carrying sheet goods on a car's roof

Dan Mitchell

>That's why we switched from a Volkswagen to a Subaru; all wheel drive.

Great pic.

Re: Carrying sheet goods on a car's roof

#4

JL

Re: Carrying sheet goods on a car's roof

JL

>I've got a Subaru Forester. I've carried lumber on my roof rack on my Forester many times - but I have the Subaru cross braces. I'm sure the rack can handle some sheets - with the cross braces.

That being said, if you plan on hauling a lot, I'd invest in a small trailer and a trailer hitch. Much easier on the back and you won't have the danger of scratching the car :).

Re: Carrying sheet goods on a car's roof

#5

Yakima or Thule crossbars.

Kneale Brownson in sunny N. MI

>

Re: Carrying sheet goods on a car's roof

#6

Re: Carrying sheet goods on a car's roof

Mark Mandell - Gone Round In Jersey

>Dan,

As stated, you'll need cross bars, but, contrary to the foto-funny, don't exceed the manual's weight limit (usually about 80 lbs), and be sure to strap the front of sheet good down to the front of the car to prevent kiting. Have seen a person rip the side rails off the roof when they went tooling down the highway and the wind caught the ply such that the lifting force exceeded the rails' durability and the whole deal pealed up and back.

I'll second the suggestion of a light trailer. Much easier and safer as well.

mm

Re: Carrying sheet goods on a car's roof

#7

I prefer Saris to Yakima or Thule

Jack

>I think they are a better design and are usually less expensive

http://www.rackoutfitters.com/car-racks/pc/Saris-Talon-50-Inch-Load-Bars-Set-of-2-88p946.htm

Re: Carrying sheet goods on a car's roof

#8

Trailer suggestion thirded

Kent in Emmaus, PA

>I'll be the third to hop on the trailer bandwagon. Easier to load and unload, much safer, lots more capacity (2 sheets of drywall is pushing the rating of most roof systems), very versatile. Once you get the load to it's destination, the trailer makes a great temporary storage / cutting area. You can also use it as a parade float, bandwagon....

Re: Carrying sheet goods on a car's roof

#9

Re: Carrying sheet goods on a car's roof

J D Thomas

>I have done this many times. I used to have an Accord wagon, and two Passat wagons, all had roof rails and I carried plywood, MDF, drywall without any issues. But...I never went over 35 mph, and at most, I only carried about 4-5 sheets. I simply tied a long rope from front to back and one or two side to side. But again, I never drove over 35. For the most part, I always felt it was a PITA. Now I have my JDUV, a pickup, as a 2nd vehicle. Personally, I like the suggestions of a trailer, or something else safer than your roof.

My 2 cents.

J D Thomas

ThomaStudios

Re: Carrying sheet goods on a car's roof

#10

Re: Carrying sheet goods on a car's roof

John E

>I agree with everyone else about the trailer (You can buy trailer "kits" from places like Harbor Freight and Northern tool that you put together and supply your own plywood flooring for only a few hundred bucks, IIRC) but wanted to offer the following comment - if you haul drywall on roof, you might want to "sandwich" it between 2 sheets of 1/2" plywood. It would be difficult to tie down drywall enough so that the wind wouldn't get under it and bend it enough to break it. Could make a real mess. Course, then weight gets to be a problem. Back to the trailer idea...

Re: Carrying sheet goods on a car's roof

#11

Way Back When

George@Colonel's Workshop-Havertown PA

>Hello Dan,

I kept a 1972 Country Squire for 12 years and hauled countless 4 X 8 sheets of plywood and drywall within the cargo compartment. Yes, it was a big car, but not gross like some SUV's, and cheaper too. The roof rack was standard equipment. I never worried about exceeding 35 mph as most of the time, the load was inside.

Why is it that when I drive any car, my wife always says the load is inside? :<)

George

Re: Carrying sheet goods on a car's roof

#12

Re: Carrying sheet goods on a car's roof *LINK*

Dan Mitchell

>Thanks for the replies on this. Actually I had considered a trailer, and the harbor freight one is attractive. I'm sure those who have experience with trailers will get a kick out of my reason for balking: I'm afraid the 1st time out, I'll get the thing all loaded up, then get stuck in some tricky uphill-at-an-angle-sideways-backup maneuver right there in the parking lot which I won't be able to accomplish & will end up abandoning the lot; car, trailer & load! Hey, it's a phobia of mine, he said only half kidding... Seriously, the way the initiated back one of those things to the right & up a driveway seems like magic to me. I guess I could hook it up and go PRACTICE on an abandoned airstrip or something.

Dan


HF trailer

Re: Carrying sheet goods on a car's roof

#13

Re: Carrying sheet goods on a car's roof

Larry Clinton

>Dan, it takes some practice to get used to backing up a 2 wheeled trailer, but you will never regret getting one or learning how to back it into tight areas. I have an overhead door on my shop, often buy large quantities of lumber at auctions. It is sure nice to be able to back the trailer into the shop, unhook it, park the car and wait till later to unload and stow the material. I have hauled hardwood plywood in the rain with my open trailer. I put a tarp on the floor, load the material, fold the tarp over the material, place a tarp on top and strap everything securely. I have driven 25 mile like that without getting a drop on the plywood. Mine is a homebuilt trailer with the rear end from a Oldsmobile Toronado. The friend that built it added pickup truck springs to the assembly and designed the trailer to tilt for transporting large tractors / mowers. He built a new double axle trailer and gave me this one for less than $5, I had to install all new lumber (2 x 6 treated bed and 2 X 12 rails / tailgate. I have carried over 2 tons without a problem, towing with my full size Dodge van at about 55 MPH, I have transported many light loads on the interstate at 65 / 70. You might want to look around your area, and local ads, to see if you can purchase a used one reasonable. My son & I have carried gravel, drywall, lumber, shingles, bricks, trash furniture, shop equipment, riding mowers, boats and many other items in the trailer that would have been impossible in a van or car and even darn unhandy in a pickup truck.

Re: Carrying sheet goods on a car's roof

#14

backing trailers

JohnKJordan in East TN

>>Seriously, the way the initiated back one of those things

>to the right & up a driveway seems like magic to me

I used to be the same way when I got my 1st. Now I can pretty much put it where I want it the first time, even backing the large trailer into a tight spot. The key to expertise, as you mentioned is practice, in the privacy of your own property or at least some parking lot. (An expert is one who makes all his mistakes in private)

One hint for backing: Forget the advice often mentioned to "turn the steering wheel in the opposite direction in which you want the trailer to go." This will only confuse things. What I do is grasp the bottom of the steering wheel and turn it in the same direction as I want the back of trailer to go. (Also, I think it is easier to back by turning around and looking out the back window than it is by using the side mirrors - if you cannot see the back end of the trailer from your choice of vehicles, attach some vertical sticks in the corners.) Try the bottom-steering method a bit and very soon you'll be able to drive the thing backwards steering up curved driveways, around trees, etc.

All the rest is getting a feel for how much steering is needed to turn without overcorrecting. Note that this is likely different for each vehicle/trailer combination. The wheelbase of the vehicle and the distances from hitch to the vehicle and trailer wheels makes a big difference. The only one I have trouble with is a yard trailer I use with one of my 4-wheelers!

I agree that a trailer is a valuable tool. Although I have two trucks I still use the trailers often. And I'd FAR rather lend a buddy a trailer than a truck!

JKJ

Re: Carrying sheet goods on a car's roof

#15

Re: A friend with a pickup truck

Peter Gregory

>Every man should have a shop and a friend with a truck. If you don't have either one, you are doing bad. If you only have one, it is time to work harder. :)

Re: Carrying sheet goods on a car's roof

#16

I Have A Shop, and I'm thge Friend with the Truck

George@Colonel's Workshop-Havertown PA

>

Re: Carrying sheet goods on a car's roof

#17

Not so bad *LINK*

Kent in Emmaus, PA

>I too was somewhat phobic about hauling a trailer, but with some advance planning, you can usually avoid tight spots. For very close quarters maneuvering it's sometimes easiest (on level ground, at least) to unhitch and move the trailer manually. A wheeled trailer jack (e.g., link below) helps a lot.


http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=91474