Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Rikon 17" noise

Posts

Rikon 17" noise

#1

Rikon 17" noise

wudwork

>I am getting a knocking sound when running a 3/4" blade. There is no obvious kink/twist/bend in blade as it is tracking right on center (where I put it) and the bearings are not moving. Yesterday I popped the circuit breaker for 1st time. This weekend I will remove blade and start it up and check it out. I was hoping someone might suggest a test to check things out. All input welcome, Thanx, Tom

Re: Rikon 17" noise

#2

Re: Rikon 17" noise

Paul Waddle

>I think its a good idea to remove blade and eliminate it as possible cause. Ordinarly a clicking sound would indicate a cracked blade,but you'd see if it tripped your circuit breaker. Next I would remove the belt. This will isolate motor from the saw and let you define where problem is coming from. I'd guess someting on the saw,but guess work don't solve problems. Good luck,pw

Re: Rikon 17" noise

#3

Blade weld?

Derek

>Did you check the blade weld? If that is not smoothly ground down or if the two ends are not butted perfectly, it can do that. Make sure the back and sides of the blade weld are not proud of the blade.

It is also a good idea to round the back long edges of the blade with a stone, but I doubt that is your problem.