Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Spot repair on lacquer question.

Posts

Spot repair on lacquer question.

#1

Spot repair on lacquer question.

Gary Evans Tallassee, TN

>Hi all,

I was asked today by a guy I used to work with at the elevator company whether I would be interested in fixing a wood wall panel in one of their elevators that has a scratch in it.

I asked him to find out what kind of finish it has and was told a "watered-down lacquer." I am assuming that this means a water-based lacquer finish. Since I don't normally work with lacquer I don't know if there is such an animal. I know that solvent-based lacquer can be spot repaired since the new coat burns into the old one, but I don't know about this stuff.

Any suggestions, or should I get more information from the manufacturer of the wall panel?

Thanks,

Gary

Re: Spot repair on lacquer question.

#2

same repair materials

Michael Dresdner

>Waterbased lacquer, if that is what it is, shares a good chunk of the same solvent package with solvent based lacquer and can be repaired with the same repair materials. Typically it is acrylic lacquer in which some of the active solvent is replaced by water, which acts as the diluent portion of the solvent mix. However, you can get back into it with acrylic lacquer thinner just as you can redissolve cured lacquer.

The problem will be if it is either waterbased polyurethane, which softens with a different solvent, or cross linked waterbased coating, which will resist virtually all solvents short of strong paint remover, and then will only come off and not dissolve. Howver, both those can be burned in, touched up and oversprayed, so for a skilled touch up person it is not much more of a challenge.

That's the good news. The bad is that working vertically in an elevator is quite challenging and because the repair will be viewed from various angles, it will show from some of them.

Re: Spot repair on lacquer question.

#3

Re: same repair materials

Gary Evans Tallassee, TN

>Thanks, Michael,

According to the manufacturer, this is a lacquer finish. Fortunately, the repair is at an upper corner of the wall panel, and thus above the normal line of sight. I'm told that it is a scratch, but I haven't seen it yet and don't know whether it is into the wood itself. That might present more problems if the wood is stained, which it probably is.

I'm looking at doing this as a favor to the company I used to work for, but I intend to get back some of what they owe me in the process.

Gary