Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

What Kind of cutter is this?

Posts

What Kind of cutter is this?

#1

What Kind of cutter is this?

Barry Irby

>I found this in my "bit" drawer and have no idea where it came from. It has a half inch shank and is about 3 1/4" long. the cutter part is 1 1/4" long and 5/8" in diameter. There are four spiral flutes. It is somewhat sharp, but not what I would call keen. It appears to be "up cutting". On it it says "5/8-HS" and "Yugoslavia". There is a cross slot int he shaft as if it could be clicked or lock into the shaft of the machine.

Anyone recognise it? High speed or low speed? Metal working or woodworking? Should I slap it into a router and give it a try or would that just set the place on fire?

Re: What Kind of cutter is this?

#2

Dale Lenz

Re: What Kind of cutter is this?

Dale Lenz

>Sounds like an end mill bit. You say it's 1/2" bit, then you describe it as having a 5/8" dia. could be milled down I guess. Not sure if you can secure an end mill with that flat spot thingy in a router or not, WOULD NOT TRY, unless you know for sure. I have ran end mills in my router for 25+ years but they don't have the flat spot thingy either.

Re: What Kind of cutter is this?

#3

That would be an end mill,

Ray Thompson - Middletown,IN

>by that description. Held in a holder by a set screw or in a collet, and no they don't feel as sharp as a wood working tool. Used for cutting soft steel in a milling machine.

Ray

Re: What Kind of cutter is this?

#4

Re: What Kind of cutter is this?

Mike Baker

>That is INDEED an "End Mill",,, 4 "flute"

A common cutter used by machinist to "mill" materials.

Toolmaker for 27 yrs regards:

Mike