Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Router table not flat

Posts

Router table not flat

#1

Router table not flat

Jeff H. - Oregon

>I have built my router table top and found that it is not completely flat. The router table is 32" x 24". I measured a dip of 0.025" in the middle front section between 12" and 24" and from front of table back 6.5". Before I laminate should I rebuild my top? Can I bondo this area to make it flat? Should I even be concerned?

Thanks for your help.

Re: Router table not flat

#2

Re: Router table not flat

Dick Coers

>I would fix the table, that's too much of a dip. What material did you use? Is the hole cut for the router? Have you cut in any miter gage slots? It will probably get worse with the weight of the router. I would cut some cleats and first clamp them to the bottom to see if the top will flatten out. If it looks good, I would laminate the bottom and then add the cleats against the laminate. Then laminate the top. You could add a couple of shims between the cleat and the bottom surface under the dip to push it up a little to take the bow out. Keep checking it and remove the shims if they move the wood too much.