Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Mast-R-Slide

Posts

Mast-R-Slide

#1

Mast-R-Slide

Doug Reynolds in Seattle

>Does anyone have any experience with the JessEm Mast-R-Slide? Looks pretty good until I can scrape up enough for a down payment on a Felder.

Re: Mast-R-Slide

#2

Fine piece of equipment

Charles R. Smith from Victoria

>I have one on a General cabinet saw. It is a very well designed and beautifully made piece of equipment. It is sufficiently solid to handle some pretty heavy tasks with thick, rough-cut lumber. Though it takes a few minutes to get it set up, the process is well explained by the manual. But it is worth it -- riding on all those bearings (32 of them, if I recall correctly), it is very smooth.

I didn't remove my extension wing, but rather drilled and tapped it such that the Mast-R-Slide runs outboard of it. I was worried that it might be too far from the blade, but it is sufficiently solid and accurate that there have been no problems. It's a nice piece of equipment which makes me very feel safe when using it.

Charles (who likes his pimped-up table saw)

Re: Mast-R-Slide

#3

Re: Mast-R-Slide

Kneale Brownson in sunny N. MI

>There's a thorough WoodCentral review HERE

Re: Mast-R-Slide

#4

Re: Mast-R-Slide *LINK*

arw01

>Garrett did an excellent review article here on Woodcentral. Go check them out on the frame to the left.

Alan


Jess-Em review

Re: Mast-R-Slide

#5

Re: Mast-R-Slide

McKay

>I have a slide on my unisaw. I had to take the wing to a machinist to have the edge machined flat. The wing's edge was not nearly flat enough. I did this because I did not want to lose the width of the saw table. Through the years, I have had many miter gauges, but this is the only one that I have really enjoyed and trusted.

Re: Mast-R-Slide

#6

Re: Mast-R-Slide

steve - Denver

>Do you get emails from Rockler and do you have a store near by? They send out 20% off coupons every once in a while and that would help with the cost of this.

Re: Mast-R-Slide

#7

Re: Mast-R-Slide

Ray Newman

>McKay: I also run a Unisaw. Did you add any form of additional support to/under the extension wing or the slider?

I've often wondered if the extension is strong enough to take on the additional weight & not sag over time??....