WoodWorking learning
Marc
>I would like to get into woodworking. Where in Northern New Jersey (about 20 miles from Manhattan) could I go to learn a bit about Shop Tools and how to use them?
Thanks,
Marc
Knowledge You Can Build On — Est. 1998
WoodWorking learning
Marc
>I would like to get into woodworking. Where in Northern New Jersey (about 20 miles from Manhattan) could I go to learn a bit about Shop Tools and how to use them?
Thanks,
Marc
Re: WoodWorking learning
George@Colonel's Workshop-Havertown PA
>Good Morning Marc,
Oftentimes, high schools aqnd comunity colleges run adult education courses during the evenings which include woodworking/cabinet making. You could check local schools. I have attended similar courses and was even asked to teach one. They offer hands-on experience, adequate supervision, and the chance to meet and work with other aspiring woodworkers. And, watch Norm.
George
Re: WoodWorking learning
Dennis Yoder
>Hi Marc and welcome to the wonderful world of woodworking. Check around for a Woodcraft or Rockler storefront and enroll in classes. Wander around these stores and ask questions. Visit woodworking shows. Enroll in nationwide woodworking schools, Mark Adams, John C. Campbell, Arrowmont, Kelly Mehler and more, subscribe to magazines, visit libraries, go to art and craft shows. Keep visiting and supporting Wood Central Dennis Yoder
Re: WoodWorking learning
Charles Sharp
>Check your local community colleges and night schools/adult ed.
Check out the New Yankee Workshop on PBS
Dave Bair, Eaton Rapids, MI
>
Re: WoodWorking learning
Tony - Memphis
>That's how I learned the basics. Good way to start because you learn (or should learn) a lot of safety items that aren't intuitive. A tape/dvd that comes to mind is Kelly Mehler's tablesaw video. Your local woodworking stores may offer classes as well. Some local clubs offer mentoring too.
Tony - been woodworking for over ten years and I'm almost not a rookie anymore!
Re: WoodWorking learning
Clint Searl, at the base of Haycock Mtn
>You don't need no stink'n school. Buy a copy of "Encyclopedia of Furniture Making" by Ernest Joyce and study it for a month. Pick a project; coffee tables are always fun. Get some wood. Figure out and acquire the tools you think you'll need. You'll be one short to complete the project, but that's a recurring phenomenon that's the rational for building your tool collection. Revel in the completion of your project and brag about how much money you saved by making it yourself.
Join a club and read this forum to learn all the jargon so you can take a seat around the cracker barrel.
Most importantly, remember that woodworking is a religion to which you must tithe.
Have fun.
Clint
Amen brother.
Art Silva
>
Try Peters Valley Craft Center in Layton
Jack
>http://www.pvcrafts.org/
Re: WoodWorking learning
Thomas S Stockton
>Marc,
Lots of good advice here. depending on the community college the courses could be anywhere from just a place to use the machinery to full on furnituremaking classes, so do some homework. Woodcraft stores offer some good classes which might be a good place to start since they tend to be one or two day affairs.
I think your best bet would be to join a local woodworking group and ask the question there, they will steer you in a good direction and help you avoid the pitfalls and are a wealth of info.
woodcentral and other message boards are great places to ask questions just be forewarned that they can also become pretty irreverent at times and don't take it seriosly or personally nobody is doing it to be mean just blowing of steam and I'm convinced we all have prtty warped senses of humor.
as for books and dvd there are some absolute classics out there along with some real junk. start by checking the links to the left for video and book reviews. In the book reviews there is also an link for essential books that is pretty right on in its recomendations.
good luck and ask questions.
Tom