Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

My Legs Need to be Longer

Posts

My Legs Need to be Longer

#1

My Legs Need to be Longer

Doug Reynolds in Seattle

>I have an old public library map table that is too low and I need to raise it up a few inches. Not concerned about any antique value and don't believe replacing the legs is an option due to them being mortised and tenoned. What are my options?

Re: My Legs Need to be Longer

#2

Four bricks

Clint Searl, at the base of Haycock Mtn

>

Re: My Legs Need to be Longer

#3

JL

Re: My Legs Need to be Longer

JL

>Are the legs tapered? If they aren't, how about making mortised extensions for each leg. Then you can just slip them over the leg ends and pin them.

Re: My Legs Need to be Longer

#4

Really tall floor pads

Mark Goodall - ATL - tooljunkie

>I had a similar situation with an antique church pew. It sat about 2-3" too low. The ends are fancy cast iron, and the coarse bottoms of those cast iron legs destroy the floor they sit on, so as I was putting some pads underthem, I went on step further, and attached them to some 2x lumber.

So now the bench sits higher and almost looks like it was meant to be like that. Or at least, it looks like when they pulled the bench up from the church, they took a section fo the floor with them, so I have the old church bench and the old church floor sitting on display in my house ;)

Happy Woodworking!

Re: My Legs Need to be Longer

#5

Overlay or leg extensions.?

Ray Carson, Lawrenceville NJ

>Place two boards at each corner and overlay the legs. ???

My 2 cents worth,

Ray


img

Re: My Legs Need to be Longer

#6

use sabots

Ian (in Sydney, Australia)

>Sabot (if I'm spelling it correctly) is French for boot or shoe, usually "wooden shoe" in English

make 'em from a contrasting timber, long enough to give you the height you need plus say 3 to 4 inches extra for the original legs to slot into.

They will even work with tapered and/or round legs.

It may even dress the table up some.

Re: My Legs Need to be Longer

#7

Re: My Legs Need to be Longer

jmohnike

>Have you considered raising the top? Remove the top install extensions to the exesting apron and re-attach top. There are many ways of doing this, and in may not be seen as much as a leg extension.

I'm suppried no one mentioned that you could always cut a hole in the floor and sit lower;-)

Joe M.

Re: My Legs Need to be Longer

#8

Do It Only On Weekends

George@Colonel's Workshop-Havertown PA

>Good Afternoon Doug,

We are enjoined by the Almighty to Keep Holy The Sabot Day. My religion lets me make the installation on Sundays. Others designate Saturday. You gotta respect each point of view. :<)

George

Re: My Legs Need to be Longer

#9

Ins't there a song with that title?

Lee Schierer - McKean, PA

>I thought a sabot was some sort of antelope, wasn't there a song about them?

Lee

Re: My Legs Need to be Longer

#10

You scragged my answer.

Art Silva

>