Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Semi OT - Siding around arched window

Posts

Semi OT - Siding around arched window

#1

Semi OT - Siding around arched window

Paul T

>Hi All,

I'm siding my garage/shop with HardiPlank. The left and right sides are now done and am about to continue the center section. The Hardi Plank instructions say I have to leave a quarter inch between the end of the clapboard and the arch portion of the window. Any idea how I could do this and also seal the gap left on the back side of the clapboards from the overlapping? I can just picture rain getting in there and running the length of the backside of the clapboards.

Paul


img

Re: Semi OT - Siding around arched window

#2

Re: Semi OT - Siding around arched window

Steve Jenkins, McKinney, TX.

>I don't know if it is right or not but I had two round windows and one like yours. I just caulked the entire space between the ends of the siding boards and the window trim.Steve

Re: Semi OT - Siding around arched window

#3

Lee Gordon

Re: Semi OT - Siding around arched window

Lee Gordon

>I think you want to bring flashing (probably soft lead) down from the wall above the window and form it over the window frame. Then apply the siding over the flashing, leaving the recommended gap between the siding and the window.

Re: Semi OT - Siding around arched window

#4

Re: Semi OT - Siding around arched window

Bill Earl

>As Lee says, you need flashing and lead is easier to work around the curves.

But I wouldn't do it in one piece. I prefer to step the flashing as you would with shingles. That ensures that any water that gets behind one clapboard will be drain over the front of the clapboard below.

Re: Semi OT - Siding around arched window

#5

Re: Semi OT - Siding around arched window

Barry Irby

>Bill and Earl are correct. You need flashing over the top of the window. Most of the manufacturers of these windows will provide a flashing that matches the shape of the arch. Either plastic or metal. Bring the siding up both sides of the window to where the arch starts and install the round flashing so that it is on top of the siding on the sides, then install the siding above the arch on top of the flashing. That way any water behind the upper siding will be lead back out on top of the siding beside the window. You can do this if you make the flashing yourself. You can also use the sticky backed material like Ice and Water Shield from the round flashing to the top of the wall or a foot or so above the window to be sure water does not infiltrate. Caulk the siding to the drip cap flashing above the window, but the calling will adhere to the siding better if you prime (and Paint) the edges of the siding first.

Re: Semi OT - Siding around arched window

#6

Re: Semi OT - Siding around arched window

Michael Wangler

>Paul,

I just put a very similar window up for a friend. It was a 'vantity' window above their garage. There was an extened nailing flange as well as a built in j-channel. The directions said to caulk the window and install the siding around the radius. So that is what I did. Some ice and water shield would probably be a good idea if you have it.

Michael