Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Finshing live edge piece with bark on it

Posts

Finshing live edge piece with bark on it

#1

Finshing live edge piece with bark on it

Mitch from TN

>I'm making a Nakashima-inspired piece that has a section of bark along one cherry board. I'm going to finish the board with oil, but I'm wondering whether I should put the oil on the bark or leave it alone. Does anyone have any experience with this?

Thanks!

Mitch

Re: Finshing live edge piece with bark on it

#2

Re: Finshing live edge piece with bark on it

Mark Mandell - Gone Round In Jersey

>I've turned natural-edge pieces and it's always a fight to keep the bark on during the drying (and warping) of the piece. Much depends on when the tree was harvested.

If your stock's dry and set, you can try soaking the bark layer with very thin CA (cyanoacrylate - super glue) to penetrate and reinforce both the bark and it's bond to the sapwood layer.

Hope this helps

Re: Finshing live edge piece with bark on it

#3

Re: Finshing live edge piece with bark on it

Clint Searl, at the base of Haycock Mtn

>Finish it the same as the rest of the piece. If the bark is tight, no problema. If it's just a bit gappy, yellow glue and clamp it back first. Otherwise, strip it off and burnish the edge with a rotary brush.

Clint