Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Removing the blade on a PC-557

Posts

Removing the blade on a PC-557

#1

Removing the blade on a PC-557

Terry Alexander

>I read a post here last week where someone was talking about the trouble they had removing the blade on their PC 557 biscuit joiner. I needed to take mine off (for the first time) to send to Scott Whiting for re-sharpening. WOW.....I had to put a foot-long "cheater bar" on the allen wrench before it broke loose. It was so tight that when it did break loose, sparks flew (literally).

So.....for those that think it might be reverse thread....it isn't.....it was just put on at the factor at about 450 ft. lbs of pressure!

FYI only.....

Terry Alexander

Re: Removing the blade on a PC-557

#2

Funny, never had that problem...

Denis Ch�nard, Orl�ans, Ont.

>And I'm the type of guy who tends to over-torque everything...

DC

Re: Removing the blade on a PC-557

#3

Re: Removing the blade on a PC-557

Scott Whiting - Glendale, AZ

>They are not that tight to begin with. However many people have broken the wrench trying to get them off. Several factors include; length of time since change, moisture, type of sawdust accumulation, and the worst is if it ever bound and stalled or almost stalled in a cut. Most folks want to get their blade off RIGHT NOW so they keep going until it comes. A little patience and spraying the threads and where the flange contacts the blade with some penetrating oil and walking away for 1/2 hour will quite often lessen the brute force needed :-)

Re: Removing the blade on a PC-557

#4

Re: Removing the blade on a PC-557

Dave's Not Here

>What works for me is to exercise the bolt that hold the blade once or twice a year. I just loosen and remove it, put a drop of oil on the thread and reinstall.

Re: Removing the blade on a PC-557

#5

Re: Removing the blade on a PC-557

DB

>I really doubt that the bolt would be torque down to 450 FT-LBS at the factory. The bolt most likely would have sheared right off. I do not remember exactly what size those bolts are but I believe that it is something in the 5/16" range which would require a maxium of 35 FT-Lbs of torque depending on the actual alloy used. For compareson a 3/4"-10 special alloy bolt would require 490 FT-LBS of torque.