Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Finished project question

Posts

Finished project question

#1

Finished project question

Eric M - San Jose

>I finished this tv stand out of birch, birch plywood, and brazilian cherry for my younger son's room. Since it's my first real project, and it's for family, I'd like to sign it somewhere, somehow, so it stays protected. Any suggestions on the best way?


img

Re: Finished project question

#2

Re: Finished project question

Dan Donaldson

>On the back of the drawer?

Re: Finished project question

#3

Re: Finished project question

Kirk (KC) Constable

>I'd sign that on the bottom, with a Sharpie.

Re: Finished project question

#4

Re: Finished project question

Barry Irby

>On the bottom, under the top, bottom of the drawer or back of the drawer. Sing it and date it. You can add a little history if you like. I would use a pencil. The carbon in the pencil "lead" is as nearly as permanent and black as anything you are likely to find. I try to remember to sign before I finish the piece so there is finish over the signature.

Re: Finished project question

#5

Re: Finished project question

Don Pierson

>Sign and date it on the drawer bottom with a woodburner.

Re: Finished project question

#6

Re: Finished project question

George@Colonel's Workshop-Havertown PA

>Hello Eric,

I sign and date all my stuff. Kids gave me a branding iron a few years ago for Christmas. That works okay, so long as its flat and at the right temp. I also inset a penny of the applicable year at an appropriate place. I also put business cards on all my work done for antique shops, and that brought a lot of repeat business as well as new customers.

George

Re: Finished project question

#7

Re: Finished project question

Robin Corell, in Atascadero CA

>I use a foredom grinder and a small burr to sign my name, the year, and the copyright symbol. I like to sign on the bottom of a table top or the bottom of a carcase for a cabinet. I usually sign a piece after it is finished, and then wipe a coat of finish over the signature.

In practice I write with a fine line sharpie what I wish to 'engrave' with the foredom. It takes a bit of practive with diferent woods to get a good signature that looks like it is a spontanious signature but I now have it down as it is part of the process of making each piece. The higher the speed of the grinding tool the easier it is to control and smoother the line is that you can draw with it.

Robin

Re: Finished project question

#8

Re: Finished project question

Eric M - San Jose

>Thank you all for your great suggestions! Mission accomplished. Signed, short note, dated, coat of poly over it, and it's in his room.

Now I just need to learn from the mistakes I made while making this. But I'm sure I'll say that after my next project also.

Although I usually don't post much, there's an incredible amount of advice, insight, encouragement, etc that I garner from reading here every day. Not to mention the beautiful work that everyone makes.

Thanks to Ellis and all who participate here for a great website!

Re: Finished project question

#9

Re: Finished project question - Very nice Eric !

Ray Carson, Lawrenceville NJ

>Eric,

I like the wood choices and it looks like the fininsh turned out great. Nice design too.

Definitely sign and date it. I'm sure you'll get hundreds of suggestions as to where to do that so I'll just leave it at that.

Nice job !

Ray