Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Larry Clinton - Follow up Dust Collection question

Posts

Larry Clinton - Follow up Dust Collection question

#1

Larry Clinton - Follow up Dust Collection question

Curtis Gray

>Larry,

Couldn't help but admire your Grizzly 0441 cyclone in the pics you posted. I am in the process of calculating my needs for my dust collection system. Presently, I plan to purchase the Shop Fox W 1687. That 3 hp machine has a 8 inch inlet also. I plan to put the collector outside my shop in a lean to building in the center of my longest wall (shop is 30' x 40') My plan is to come off of the 8 inch inlet with 2- 6 inch pvc pipes and run them in opposite directions, thus, ending up with 2 - 20 ft runs for the main. All of the biggest dust offenders will be nearest the collector, ie. 15 inch planer, 10 inch cabinet saw, jointer, etc. Do you anticipate any problems with reducing the 8 inch inlet to two 6 inch lines? Thanks for your help.

Re: Larry Clinton - Follow up Dust Collection question

#2

Re: Larry Clinton - Follow up Dust Collection ques

Larry Clinton At Frankfort (Central)., Indiana

>Curtis, that is the way mine is set up. The top take off of 6" pipe runs up to my 10' ceiling, across the 30' shop, down the other wall - then I have a 10' section of 6' flex pipe hooked to my 20" Yorkcraft planer. The system doesn't seem to have any problem pulling all the sawdust/chips from the planer (and it really can make chips!). I have a 6" takeoff from that line about in the center of the shop running to my 8" jointer, total run length about 40' with an additional 10' of 4" flex line, again no problem. I do try to keep one of these gates closed when using the other machine as the jointer will accumulate some dust if the planer gate is also open. However the 2nd 6" run goes to my table saw, band saw, and (not completed yet) benchtop morticer and CMS, I often leave these (4" blast gates) open while using the planer or jointer without seeing much effect on the system. You shouldn't have any problems.

Re: Larry Clinton - Follow up Dust Collection question

#3

Re: Larry Clinton - Follow up Dust Collection ques

Curtis Gray

>Larry, sounds to me like you have more than enough capacity on the collector. My shop is a one man hobby shop, so no 2 machines will ever be on at the same time. Distance from the collector to the planer (15 inch) will probably be about 10 ft, and about 15 ft to the table saw. I was concerned about making the bends to go both directions,and reducing the suction significantly, but your post makes me feel better about the plan. Thanks for your help.

Re: Larry Clinton - Follow up Dust Collection question

#4

Found It Again *LINK*

Mark Mandell - Gone Round In Jersey

>Curtis,

The link is to Larry Harder's pipe-joint cutting program. I think you'll find it usefull.

MM


Piping Program

Re: Larry Clinton - Follow up Dust Collection question

#5

Correction

Mark Mandell - Gone Round In Jersey

>That's "Stan" Harder

(Sorry Stan)

Sorry, "Larry" (whoever you are)

|;-}}

Re: Larry Clinton - Follow up Dust Collection question

#6

Re: Correction

Curtis Gray

>Mark,

The site looks to be very useful . Thanks.