Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Radial Arm Saw blade suggestions

Posts

Radial Arm Saw blade suggestions

#1

Radial Arm Saw blade suggestions

Gary Evans Tallassee, TN

>Hi all,

I need to buy a blade for my new (to me) Dewalt 14" RAS. We are going to be using it primarily for cross-cutting up to 4" thick material, though I'd like to be able to turn the square around and trim an edge occasionally too. Freud has an assortment of combination and general purpose blades in 14" from $70 to $130. Woodworker Supply is the only source I've checked so far.

Does anyone have recommendations on blades and sources? For a RAS this size, I'd prefer a blade that doesn't jump at you everytime you touch it to the wood. Less aggressive, I guess.

Thanks,

Gary

Re: Radial Arm Saw blade suggestions

#2

Re: Radial Arm Saw blade suggestions

Clint Searl, at the base of Haycock Mtn

>For that size blade and the kind of work you'll be doing, I suggest a blade with Cermet tips. Check out http://www.carbideprocessors.com/saws/intro.htm

They can arrange to get you a custom blade made. I would guess that an 85 to 95 tooth configuration would work well.

They got me a 10" 40 tooth blade w Cermet tips for my table saw and it will cut anything and remain sharp. Pricy but worth it.

Clint

Re: Radial Arm Saw blade suggestions

#3

Negative Hook Tooth

Mike Fitterling

>Freud makes the LU91 with a -5 degree rake; Ridge Carbide makes an excellent negative hook blade as well. That will go a long ways toward reducing climbing. However, your carriage bearings could be adjusted too loose, adding to the problem. Snug them up so that you have to pull a little to start the carriage moving. You shouldn't be able to put a finger to the carriage and with a flick send it flying down the arm; it should be snug. Properly adjusted bearings combined with a negative hook blade will reduce climbing to almost nothing.

Cheers,

Mike

Re: Radial Arm Saw blade suggestions

#4

Ditto on Negative Hook

Tim Greif - West of Chicago

>I have the Freud LU91 on my RAS and it's incredible how the negative hook feature eliminates the tendency for the blade to jump into or climb through the cut. Much easer to control. However I think it's only available up to 12-inch size.

Re: Radial Arm Saw blade suggestions

#5

Re: Ditto on Negative Hook

Gary Evans Tallassee, TN

>That's all that's shown in the Woodworker's supply. I'll be looking around to see what else I can find with a negative hook.

Thanks to all of you,

Gary