Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Questions on Rubbing out a finish.

Posts

Questions on Rubbing out a finish.

#1

Questions on Rubbing out a finish.

Barry Irby

>On advice gotten here, I went out and purchased 2F and 4F pumice, rottenstone, Paraffin oil, and felt blocks.

I have rubbed two pieces I shellaced. Pretty happy with the results, but I have a few questions.

I bought a felt pad for each grit. I am keeping each one in its own zip lock bag.

I wipe the piece thoroughly between each grit. The question is, is there still some contamination of the blocks? Do I need to clean them? If so, How? Do you clean the piece more than just wiping it? Do you use oil or solvent?

Is there a good book or video on this? (Finishing)

Another question. If you wanted to cover the shellac with another coat or you wanted to put lacquer or some other finish over it, how would you remove the oil and any residue of grit?

Re: Questions on Rubbing out a finish.

#2

Sending Guido to Helsinki?

Mark Goodall - ATL - tooljunkie

>

Re: Questions on Rubbing out a finish.

#3

Re: Questions on Rubbing out a finish.

Steve Schoene

>Mineral spirits or naptha would remove the oil.

I've generally not found it necessary to use both grades of pumice. You can go directly from sandpaper--say 1000 grit--to the fine pumice if you want a satin finish. If you are going for a gloss finish, you can sand with one grit finer, 1200 or 1500 and go directly to rottenstone.