Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Quick help with face frame options...

Posts

Quick help with face frame options...

#1

Quick help with face frame options...

Rob Hix - King George, VA

>Hey all,

Back to the bookshelves. I am having more trouble with these things than a little. My latest is the face frame joints. In an effort to make a single face frame across a 13 foot set of bookshelves I have found myself in a pickle. I do not have the room to assemble the whole face frame to sand the joints flush before finishing. I talked with the customer tonight and we decided to build four separate face frames. With the hope that no planer would be needed I went to Lowe's and picked up a 3/4" oak board. Much to my dismay, this thing is about 1/16" thicker than the current face frame material. So, out comes the planer anyway. With the wheels still turning in my mind I come up with another option. Plane down the rails of the face frame about 1/16" or maybe a hair more. This would make the stile sit proud of the rail by about 1/16". Then, run a 1/16" chamfer down each side of the stile. It would look something like this:

Photo Sharing and Video Hosting at Photobucket

Another option is top plane the rails down by 1/8" and run a 1/16" chamfer on the stiles. This would look something like this:

Photo Sharing and Video Hosting at Photobucket

So, I have three options. Which do you all like best?

(1) Rebuild the face frames into four separate units and attach then to the shelves before installation.

(2) Put a 1/16" chamfer on the stile and plane the rails down to meet the bottom of the chamfer (or close

to it)

(2) Put a 1/16: chamfer on the stil and plane the rails down 1/8".

Please help if you can. I need to get started on this mid morning tomorrow. All answers or further ideas are welcome too.

Thanks again,

Rob Hix

Re: Quick help with face frame options...

#2

None of the Above.......

Barry Irby

>From a practical point of view I would choose the variation where there is and 1/8" difference so that the surface of the rail does not have to match the edge of the chamfer. That way if the rail is "in or out" a 1/32 or even a 1/16" it won't "show" (much). But, I would chamfer the edges of the the rails also. This might require keeping up with tops and bottoms, but it woudl keep the appearance consistent and make the edges more pleasant to the touch and more durable. Chamfering would be fine, but a 1/8" radius would work also, if you have a router bit that will do it. The radius would be easier to sand if you need to.

Also, this is a place where biscuits in the face frames might pay off and so would pocket screws.

Re: Quick help with face frame options...

#3

Re: None of the Above.......

Kneale Brownson in sunny N. MI

>Pocket screw use would require a shim on the "good" side to keep the backs of the rail/stile aligned correctly. But it would be the better joint, I'd think.

I agree you want all memeber edges treated the same way.

Re: Quick help with face frame options...

#4

Re: Quick help with face frame options...

Rob Hix - King George, VA

>Hey all,

After sleeping on it I have decided that the best way to go is to build four separate frames. Not only s this minimal impact, but it also get me done quicker (I have only two and a half weeks) and it solves some installation problems that we are afraid we might have.

Thanks all for the input. I need to get out and get to work now. It is going to be a LONG LONG day.

Thanks,

Rob Hix